Num'axes CANICOM 200 Manual De Instrucciones página 20

CODING PROCEDURE
1. Activate the remote control: press for 1 second the On/Off red button
remote control.
2. Receiver collar in position « deactivated » (indicator off): approach the red indicator located on the
remote control until coming in contact on red indicator located on the receiver collar, hold
for 6 seconds. The indicator lights in fixed green, then flashes in red.
3. Move the remote control away from the receiver collar. How to use the remote control
4. Press the button
with your remote control.
u Reprogram a receiver collar
Collar can be re-coded indefinitely, either with the same remote control, or with a new CANICOM
remote control. Ref. § coding procedure.
The CANICOM 200 remote control is designed to operate with 1 receiver collar.
button: beeper
If you press the « Beeper » button
this function: the beeper will continue to sound for as long as the button is pressed.
It's up to you to use the beeper depending on the way you want to train your dog. With the beeper button
you can:
- send a sound to your dog when it is disobedient,
- draw its attention,...
It's very important to always use the beeper button in the same way in order not to disturb
your dog.
v F button: Flash stimulation
Press the «F» button to send a warning to your dog using stimulations transmitted by the two contact
points located on the receiver collar for a defined length of time of less than one second.
v C button: Continuous stimulation
Press the «C» button to send a warning to your dog using stimulations transmitted by the two contact
points located on the receiver collar, this will last for as long as the button is pressed but limited to
8 seconds maximum.
v
of the remote control. A beep sound is emitted, the collar is then synchronized
the receiver collar will emit sound signals. There is no time limit for
Gb - 20
located on the side of the
( (