Leatt HARD SHELL Manual De Instrucciones página 4

Fitment
1a. 1b.
1c.
Front Back
2a.
The front plate of the
protector should align with
the top of the sternum (2a).
The back plate should
run along the spine, with
the widest part covering
the shoulder blade (2b). If
the protector sits too high
or too low, adjustment is
neccessary.
Adjustment
3a. 3b.
5
To fi t your 5.5 Chest Protector
Pro HD, unclip the buckles on
the chest (1a). Separate the
arm straps (1b). Proceed to
pull the protector over your
head, make sure the protector
is the right way around (1c).
Fasten all the buckles and
straps.
2b.
The waist belt can
easily be adjusted
by moving the belt
adjuster. In, to go
tighter (3a), out for
more slack (3b).
®
Copyright © 2013, Leatt Corporation
4a. 4b.
To adjust the fl ank padding, open the panels on the inside of the back protector
(4b). Now you can unhook, move and rehook the fl ank padding in your preferred
postion(4c).
5a.
5b.
To adjust the shoulders, use the shoulder tab and seperate the shoulder strap
(5b), realign the shoulder strap in your preferred position and join the velcro (5c).
6a. 6b.
The shoulder guards can be ajusted by opening the inside of the shoulder cup (6b).
Unhook ,reposition and rehook the shoulder straps to your required lenght (6c).
7a.
7b.
Removing the entire shoulder requires you to completely slide the shoulder
straps out of the shoulder cup (6c) and then removing the shoulder straps from
the protector (7a). To remove the arm padding, simply unclip the connector
strap(7b) and slide it out (7c).
®
Copyright © 2013, Leatt Corporation
4c.
5c.
6c.
7c.
6