Maintenance - T.I.P. 18000 3D Traducción De Las Instrucciones De Uso Originales

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
Plug in the mains cable of the switch box. The LED indicator of the currently selected mode lights up. It is now
possible to choose between two operating modes, depending on the pool size and degree of contamination
Fig. 4
Possible operating modes:
Start/Stop
:
You can start and stop the device with this
Floor clean:
The device only cleans the floor
(Attention: depending on the pool-wall transition, the device may also move up the wall)
Floor + wall clean:
Time:
Press several times before starting to select the cleaning time
2 hours:
3 hours:
5 hours:
First select the desired operating mode by pressing the respective button once.
Then set the desired time (TIME) and confirm your choice with the "Start/Stop" button ( ). The device starts the
cleaning operation. If you wish to interrupt the device prematurely, press the "Start/Stop" button ( ) again.
When the cycle is finished, the cleaner stops automatically. Disconnect the mains cable of the switch box from the
mains supply. Using the cable, pull the robot carefully towards you and to the surface. Make sure that the under-
side is facing the pool wall. Slowly take the pool robot out of the pool by the handle and hold the pool robot over
the pool to allow the water inside to run out.

6. Maintenance

ATTENTION: Before performing any maintenance tasks, disconnect the electrical device from the
power source by pulling the plug out of the socket outlet.
Do not use aggressive solvents or cleaning agents.
Do not dispose of pool water containing chemicals (e.g. chlorine) on lawns or plants.
Disconnect the device from the power source.
Place the cleaner on a level surface.
Open the two covers and remove the two filter baskets (Fig. 5).
Please remove all dirt and water from inside the pool robot.
Also clean the filter baskets regularly by pushing the side grilles upwards and thoroughly cleaning and
rinsing them (Fig. 6).
The cleaning intervals depend on the degree of soiling of the water.
Assemble the device in the reverse order to ready it for use again (Fig. 7).
The device cleans pool floor and walls
red light
green light
blue light
4
11
loading