Adjust The Height Of The Telescopic Arm; Adjusting The Working Angle; Trouble Shooting; Switching On And Off (With Telescopic Arm) - Grizzly Tools AGS 108-2 Lion Traducción Del Manual De Instrucciones Original

Adjust the height of the
telescopic arm
Adjust the length of the telescopic arm for
your size with the help of the adjusting
screw (22).
Adjusting the working
angle
For a comfortable edge cut, the equip-
ment holder (20) of the telescopic arm can
be rotated to the right or left.
Set the desired position by pulling the
release switch (23) and rotating the equip-
ment holder (20) of the telescopic arm.
The equipment holder locks into the de-
sired position when the release switch is
released.

Trouble shooting

Problem Possible Cause
Equipment is not charged
Switch lock (
Device doesn't
been operated properly
start
On/off switch (
defective
Too much friction due to
lack of lubrication
Dirty blade (
Bad cutting
results
Blade (
has nicks
Blade (
aged
1. Remove the blade guard (
2. To switch on, hold the switch lock (24)
3. To turn it off, release the on/off switch
Working with the telescopic
arm
•
2) has not
8) may be
10/13)
10/13) is blunt or
10/13) is dam-
Switching on and off
(with telescopic arm)
before switching the device on.
on the handle of the telescopic arm
and simultaneously press the on/off
switch (25). Release the switch lock,
device runs at top speed.
(25).
Slowly push the device on the wheels
over the floor. By doing so, you will
achieve an even cutting height.

Error correction

Charge equipment (see „Charging pro-
cess")
Switch on (see „Operation")
Repair by Service Centre
Lubricate blade (
(see „Cleaning/Maintenance")
Clean blade
(see „Cleaning/Maintenance")
Sharpen blade (see „Cleaning/Mainte-
nance") or replace (see „Spare parts/
Accessories")
Replace blade
(see „Spare parts/Accessories")
GB
12/15)
10/13)
83