Uline H-2171 Instrucciones De Ensamblaje página 5

3. Set top assembly on cabinets, placing bolt heads in
keyhole slots, then slide forward. (See Figure 16)
Figure 16
4. Position top so that ends of top are flush with sides of
cabinets and tighten all bolts.
5. Replace drawers or close cabinet doors.
1 PEDESTAL, 1 LEG ASSEMBLY
LEG ASSEMBLY
1. Insert adjustable feet into leg and slide into place.
Make sure that three holes are showing near the
bottom of the leg. This will give your leg a height of
32⁄". (See Figure 17)
NOTE: If desired, insert locking tabs through
legs and adjustable feet to lock feet into place.
Figure 17
PAGE 5 OF 18
STEEL TOP ASSEMBLY CONTINUED
Adjustable Feet
3 Holes
2. Align bracket to outside of each leg and secure
using two bolts, two lock washers and two nuts per
bracket. (See Figure 18)
NOTE: Do not tighten bolts.
NOTE: Brackets must be facing the same direction.
Figure 18
MOUNTING STEEL TOP TO LEG
1. Place tabletop on a smooth, non-marring surface
with top side facing down.
2. Align leg holes to end of tabletop. Secure with eight
1/4"-20 x 5/8" bolts. Threaded inserts are provided on
each tabletop end. Use four nuts and four locking
washers to secure remaining bolts. (See Figure 19)
Leg
Side
Threaded
Insert
Figure 19
Lock
Washer
Leg
Bolt
Nut
Bracket
Tabletop
Bolt
Bolt
Lock
Bolt
Washer
Nut
1120 IH-2171