Miele WTS 510 Instrucciones De Montaje página 20

M.-Nr. 09469886
A
Tighten the screws on the eccentric cams (2), see Fig. 8.
A
Level the machine and plinth using a spirit level.
A
Counter the plinth feet.
A
Secure the plinth to the floor with the floor fastening fitting kit, Mat. no. 06593051.
Installing the plinth under the washing machine
Before the actual assembly, the connection pieces are secured on the plinth. They are used to connect two plinths
securely together. Tighten the connection pieces even if a second plinth is not to be used. This will avoid possibly
difficult retro fitting and also ensures that the connection pieces are stored safely.
Installation of dryer on left and washing machine on right: See Fig. 9.
Installation of washing machine on left and dryer on right: See Fig. 10.
A
Use a pipe wrench to hold the threaded bolts in the plinth and remove the plinth feet.
A
Unscrew 2 plinth feet from the left or right side, depending on the installation setup; see Fig. 9 or Fig. 10.
A
Fit the washers on the drip tray, see Fig. 9 or Fig. 10.
A
Install the connection pieces (1) on the washers; see Fig. 9 or Fig. 10.
A
Screw on the 2 plinth feet but don't secure them with the counter nuts yet.
NOTE
Damage to washing machine and flooring.
A
Drain all water out of the washing machine.
A
Remove the dispenser unit.
A
The washing machine must only be tilted onto its side with the transport struts fitted.
A
The washing machine must be laid on a flat, soft underlay (e.g. a carpet).
A
Fit the transport struts if they are not already fitted; see the operating instructions.
A
Lay the washing machine on its side.
A
Unscrew and remove the washing machine's feet.
A
Fit the spacer sleeves (1) on the threaded bolts see Fig. 11.
A
Connect the plinth and the washing machine together.
A
Tighten the bolts with an open spanner from inside the plinth. Tighten the bolts alternately to ensure even tightening.
A
Stand the combination upright.
A
Fit the sealing strips as shown on the inside of the rear panel, see Fig. 6.
A
Use 3 CEM 4 x 10 raised-head screws to fit the rear panel on the plinth, see Fig. 12.
A
Level the machine and plinth using a spirit level.
A
Twist in the connection pieces on the plinth.
A
Counter the plinth feet.
A
Secure the plinth to the floor with the floor fastening fitting kit, Mat. no. 06593051.
NOTE
A
Remove the transport struts.
Drawer fitting
A
Place the drawer on the plinth drawer rails and close the drawer.
 The drawer audibly locks into position.
A
To ensure that the drawer is correctly located on the rails, open it again and slam it shut.
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
20 von 83
26.02.2021
loading

Este manual también es adecuado para:

Apcl 0410932230011477320