JCLASS WLBS008-30AC-GNNN Manual De Programación página 12

ADVANCED PROGRAMMING
GB
7.9
WASHING HOURS
How to change
the setting
NO
Press this button to go to the
next screen
A series of screens appears showing how much water has been consumed for each type and dose; these values cannot be reset.
7.10
Pulse-dispensed water is also counted
Press this button to go to the next
screens
PARTIAL LITERS
How to reset
the counter
NO
Press this button to go to the
next screen
TOTAL LITERS
Press this button to go to the
next screen
12
This function instructs the water cooler on when to wash the hydraulic circuit.
?
It should be used only on coolers that are provided with an efficient drainage
system connected to a sink. Test the drain by discharging at least 18 litres of
water before you use this function.
The setting represents the number of hours between two successive washes,
and accepts values from 1 to 240 hours.
Washing requires enabling the three dispensing solenoid valves to open for two
minutes each, one after the other. A specific message will appear on the display.
The water cooler is delivered with washing not enabled.
YES
?
This counter shows the number of litres dispensed in doses from all the
nozzles.
It is called subtotal counter because it can be reset to zero.
YES
?
This counter shows the total number of litres dispensed by the water cooler
from the date of construction; the counter cannot be reset
Buttons 1-2 for setting the interval (in hours) between washes
Press this button to confirm.
Press and hold the button