Mounting; Operation - Grizzly Tools ELS 2614-2 E Traducción Del Manual De Instrucciones Original

- Casing handle with 2 attachment
screws (short)
- Guide rollers with holder
- Motor casing
- Carrying strap
- Collection bag with bag holder nozzle
- Instruction Manual

Mounting

Before putting the device into
operation, the blower / suc-
tion tube must be completely
mounted and screwed tight and
the collection bag and carrying
strap must be attached.
Mounting the casing handle
1. Slide the casing handle (9) over
the handle retainers on the up-
per and rear motor casing (11).
2. Check that it is firmly in place.
3. Tighten the casing handle (9)
with the 2 enclosed screws.
Mounting the blower/suction
tube
4. Pull apart the sections of the
blower/suction tube (2a+2b)
which are inserted inside each
other.
5. Plug the two sections of the
blower/suction tube (2a+2b) into
each other and screw them to-
gether (3a).
6. Plug the upper blower/suction
tube (2b) into the blowing/suc-
tion hole on the motor casing
(10).
7. Fix the blower/suction tube using
the fastening screw (3a + 3b).
Installing the guide rollers
8. Push the holder (21) over the
lower blower/suction tube (2a)
and screw it tight.
9. Attach the guide rollers (1) on to
the holder (21) on the right and
left. These lock into place.
Fitting the collection bag
10. Place the retainer frame (15) onto
the opening on the motor casing
(10) such that the click-in fasten-
ers (22) audibly click into place.
11. Fix the loops (18a+b) from the
collection bag (16) to the upper
blower/suction tube (2b) and the
device casing (10).
Mount carrying strap:
Open the closure on the carry-
ing strap (16).
Hook the carrying strap (5) into
the mounting eye (6) on the mo-
tor casing (11). Shut the closure
on the carrying strap.

Operation

Danger of injury.
Wear suitable clothing and work
gloves when working with the
device. Make sure that the device
is functioning properly before
every use. Make sure that the
collection bag and the tube are
assembled correctly and the car-
rying strap is adjusted correctly
for work. If a switch should be
damaged, work with the device
must not be carried out any
longer. Make sure that the mains
voltage values are compatible
with the label on the device.
GB
67