Gorenje Tiki OTG 30 SLIM Manual Del Usuario página 16

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 72
Dear buyer, we thank you for purchase of our product.
PLEASE READ THE INSTRUCTIONS THOROUGHLY PRIOR TO THE
INSTALLATION AND FIRST USE OF THE WATER HEATER.
THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING
CHILDREN) WITH REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES,
OR LACK OF EXPERIENCE AND KNOWLEDGE, UNLESS THEY HAVE BEEN GIVEN
SUPERVISION OR INSTRUCTION CONCERNING USE OF THE APPLIANCE BY
PERSON RESPONSIBLE FOR THEIR SAFETY.
CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY DO NOT PLAY WITH
THE APPLIANCE.
This water heater has been manufactured in compliance with the relevant standards and tested by
the relevant authorities as indicated by the Safety Certificate and the Electromagnetic Compatibility
Certificate. Its basic technical properties are stated upon the nameplate, glued between the
connection pipes. The water heater may be connected to water and electric power supply only by
a qualified specialist. The reach in its inside due to the repair or removal of limestone and checking
and replacement of anti-corrosion protection anode may be performed only by an authorised service
workshop.
INSTALLATION
The water heater should be installed as close as possible to the points of use to avoid heat dispersion
along the pipes. It should be fastened to the wall with appropriate bolts with minimum diameter of
8 mm. In case the wall in question cannot support the weight three times that of the heater filled
with water, the relevant section of the wall (where the heater is to be installed) must be suitably
reinforced. OTG water heater must be mounted to the wall in the upright position.
TECHNICAL PROPERTIES OF THE APPLIANCE
Type
Model
Volume
Rated pressure
Weight / Filled with water
Anti-corrosion protection of tank
Connected power
Voltage
Degree of protection
Grad des Apparatschutzes
Heating time to 75°C
1)
Quantity of mixed water at 40°C [l]
Energy consumption
[kWh/24h]
2)
1) Time for heating of the whole volume of heater with electric immersion heater by entering temperature of cold water
from water supply 15°C.
2) Energy consumption to maintain stable temperature of water in the water heater 65°C at surrounding temperature
20°C, measured according to DIN 44532.
16
OTG 30 N
OTG 50 N
OTG 30
OTG 50
SLIM
SLIM
[l]
30
[MPa]
[kg]
19/49
24/74
[W]
[V~]
05
[h]
1
1
58
0,90
0,99
OTG 65 N
OTG 80 N OTG 100 N OTG 120 N
OTG 65
OTG 80
SLIM
SLIM
50
65
0,6
28/93
31/111
Enameled / Mg Anode
2000
230
I
IP 24
55
30
2
94
124
148
1, 1 3
1,26
OTG 100
OTG 120
SLIM
SLIM
80
100
36/136
41/161
05
55
3
3
194
1,71
1,81
120
35
4
226
Tabla de contenido
loading

Este manual también es adecuado para:

Otg 50 slimOtg 65 slimOtg 80 slimOtg 100 slimOtg 120 slim

Tabla de contenido