Assembly; Install Wheel Kit; Carton Contents - Snapper 5600W Manual Del Propietário

ASSEMBLY

Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-317-7833. If calling for assistance, please have the
model, revision, and serial number from the data tag available.
Remove Generator From Carton
1. Set the carton on a rigid flat surface with "This Side
Up" arrows pointing upward.
2. Carefully open the top flaps of the shipping carton.
3. Cut down corners at one end of carton from top to
bottom and lay that side of carton down flat.
4. Remove all packing material, carton fillers, etc.
5. Remove the generator from the shipping carton.

Carton Contents

Check all contents against those listed below:
• Main unit
• Engine oil
Figure 1 — Install Wheel Kit
Hex Nut
Handle Assembly
Use existing hardware
to attach left side of
support leg to unit
Support Leg
Vibration Mount
Snapper 5600W Portable Generator
Cap Screw
Hex Nut
Hex Nut
Cap Screw
• Owner's manual
• Engine manual
• Wheel kit
If any parts are missing or damaged, call the generator
helpline at 1-800-317-7833.

INSTALL WHEEL KIT

NOTE: While the wheel kit is designed to greatly improve
the portability of your generator, it is not intended for
over-the-road use.
You will need a 1/2" or 13mm socket wrench, a 1/2" or
13mm open end wrench, a 7/16" socket wrench, 7/16" open
end wrench and a needle-nose pliers to install this kit.
NOTE: Adjustable wrenches may be substituted for open
end wrenches.
Install the 10" Wheel Kit as Follows:
1. Place the bottom of the generator cradle on a flat,
even surface.Temporarily place unit on blocks to ease
assembly.
2. Slide axle through both axle mounting brackets on
cradle frame, as shown in Figure 1.
3. Slide a wheel over the axle.
Axle
Cap Screw
E-Ring
6
Wheel
Flat Washer