Troubleshooting - Worx WG163 Manual De Instrucciones

MAINTENANCE
After use, disconnect the battery from the tool and
check for damage.
Your power tool requires no additional lubrication
or maintenance. There are no user serviceable parts

TROUBLESHOOTING

The following table gives problems and actions that you can perform if your machine does not operate
correctly. If these do not identify and correct the problem, contact your WORX Customer Service at 1-866-354-
WORX.
itch the machine off and remove the battery prior to any troubleshooting.
WARNING: Sw
Problems
Trimmer fails to Battery discharged.
operate.
Battery too hot/cold.
Motor is broken.
Internal wiring of machine damaged.
Trimmer runs Motor is broken.
intermittently. Battery not fully charged.
On/Off switch defective.
Excessive vibrations/ Machine defective.
noise. Line spool is not wound well.
Cutting time per
Battery has not been used for long period
battery charge
or only charged for short term.
too short.
Grass too high.
Battery defective.
Machine does not cut. Line broken.
Battery not fully charged.
Motor is broken (speed is too low).
Grass entangled around cutting head.
Continuous lighting Battery not (properly) inserted.
of the battery charge
indicator. Battery contacts contaminated.
No charging
procedure possible. Battery defective.
Battery charge Plug of battery charger not plugged in
indicator does not (properly).
light up. Socket outlet, mains cable or battery
charger defective.
Command feed does Cutting line is not wound well.
not work The line is tangled.
Line is used up.
2 in 1 Cordless Trimmer/Edger
All manuals and user guides at all-guides.com
in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with
a dry cloth. Always store your power tool in a dry
place, and out of the reach of children. Keep the
motor ventilation slots clean. Keep all working
controls free of dust.
Possible Causes Corrective Action
Recharge battery; also see
the content in charger manual
Allow to cool/warm.
Contact Service Agent.
Contact Service Agent.
Contact Service Agent.
Recharge battery.
Contact Service Agent.
Contact Service Agent.
Rewind the line. See "MANUALLY
WINDING THE LINE" (Fig. O1, O2, O3, O4).
Recharge battery; also see
the content in charger manual.
Cut in stages.
Replace the battery.
Replace the line
Recharge battery; also see
the content in charger manual.
Contact Service Agent.
Remove grass.
Properly insert battery into battery
charger.
Clean the battery contacts or replace
the battery.
Replace the battery.
Insert mains plug (fully) into the
socket outlet.
Check the mains voltage; have
the battery charger checked by an
authorized after-sales service agent.
Manually feed the line, if still cannot
feed out, remove the Spool out and
rewind the line.
Replace with a new spool of line.
13
EN