DART Controls PU-E Serie Manual Del Usuario

PU-E SERIES INSTALLATION & DIMENSIONS
Step 1 Tap motor shaft for 10-32 screw, 1/2" deep
Step 2 Remove cap from screw
Step 3 Remove black dust cover
Step 4 Install and tighten PU-E assembly
10-32
screw
dust
cover
Step 5 Secure black cover onto housing
LTPUG
PU-E
bearing
flat
washer
magnet
disc
black wire
common
white wire
signal
DO NOT OVERTIGHTEN SCREW !!
No other screws are necessary, as
the cord will keep the unit from
rotating. The PU-E gives a high
signal when the North Pole in the
magnet crosses the hall-effect
transistor. The signal is switched off
when the South Pole crosses the
hall-effect transistor. The result is a
square wave whose frequency is
proportional to the speed of the
shaft that the PU-E is mounted on.
The number of North/South Pole
pairs directly affects the output.
tapped
motor
shaft
3/16"
spacer
red wire
+VDC
(note: can be used
on +5 through +24
volt power supply)
A-5-3281D
Note:
If installing the unit on a motor
purchased from Dart, the motor
shaft is already drilled and tapped.
If the motor is fan-cooled (TENV),
remove the plug in the center of
the fan guard before installing the
pickup. Otherwise, damage to the
pickup may occur.
1.60
2.40
72.00
.875