EN
Removing Sensors from the K1/K2 Hub
In the smanos home app accessories page, slide the sensor from
right to left. Then tap on the ashbin icon to remove sensor from the
hub.
Installation Mode
To initiate installation, set the Sensors to installation mode from
the smanos home app on the IR beam sensors page or press the
installation mode button in the receiver circuit board, then put it
back into the beam bar. Insert the waterproof rubber plug and
cover the installation cap.
After pressing the installation mode button, the receiver will beep
accordingly to signal strength. Higher frequencies indicate a
stronger signal. A beep every 3 seconds indicate no signal.
The device will exit installation mode after the receiver receives a
stable connection signal between transmitter and receiver (duration
varies by signal strength) or automatically after 30 minutes. You can
also exit manually by setting the installation mode to off.
Fixation
1. Activate installation mode. Put the transmitter to the target place
and adjust the distance between the transmitter and receiver. We
recommend installing the IR sensors on doors or windows, within
the range of the K1/K2 Hub. The gap between the transmitter and
receiver should be no more than 6 meters apart.
Note: The transmitter and receiver must be aligned to each other,
and maintain the same distance from the ground.
2. Mark the screw holes of the transmitter, then use the hole punch
to punch two screw holes. Insert the expansion bolt, then fix the
transmitter with screws.
3. Adjust the receiver on the other side of the detection area. Make
sure the buzzer rate is high (2-3 beeps within 1 second intervals).
Fix the receiver as necessary after adjusting.
EN
Horizontal Leveller
