Desoutter ASD Manual De Instrucciones página 22

6159933860
Issue no: 06
4.1.5. Step 5
This step is only necessary if your screw thread
diameter is greater than 2mm.
See Picture I - page 17
Legend
1 Stopper spring
2 Stopper
3 Screw
4 Washer
● Place the stopper spring under stopper and
remove the screw and washer. Install proper
size stopper based on screw size.
● Reinstall washer and screw.
● Move stopper spring back to its original
position.
4.1.6. Step 6
See Picture J - page 18
Legend
1 Rail
2 Tab
● Carefully install rail back to machine paying
close attention to the correct position.
Note: Tab on the bottom of the rail must come
into contact with the metal on inside of the
feeder.
4.1.7. Step 7
See Picture K - page 18
Legend
1 Hex key
2 Screw
● Lock the rail and close the side gate.
Note: ensure side gate does not make contact
with the rail, leave a small gap between the rail
and gate as to not allow a screw to become
lodged in gap.
Turn side gate screw counter
clockwise to close.
DO NOT REMOVE SCREW!
22 / 140
4.1.8. Step 8
See Picture L - page 18
Legend
1 Hopper
2 Screw
● Make sure hopper is centered on the rail,
if not, adjust the hopper from rear of the
machine by carefully loosening the two
screws by 2 turns, make the adjustment then
tighten the screws.
Do not remove the screws.
4.1.9. Step 9
See Picture M - page 18
Legend
1 Screw
2 Brush
3 Screw
● Place a few screws into the rail below the
brush.
● Sweep brush across the rail.
● The brush should not come into contact with
the ramp and should just contact the top of
the screw heads
Do not force brush!
4.1.10. Step 10
● Measure and record the head of the screw.
See Picture N - page 19
Legend
1 Measurement shim
2 Screw
● Loosen the screws. These allow for up and
down adjustment of the pedestal.
● Using the proper combination of measuring
shims, place the shims between the pedestal
and rail and lightly press down on the
pedestal while tightening the screws which
will allow most accurate height adjustment,
then remove the shims.
Note: the gap between the rail and pedestal
should be slightly more then the actual screw
head height.
Ex: For 2mm headed screw, used (1) - 1.0 and
(1) - 1.2mm measurement shims to equal a 2.2
gap.
10/2018