Installation Positioning / Electrical Connection; Building In The Appliance Under A Worttop - Kuppersbusch IKU 159-0 Istrucciones Para El Uso

Installation
Positioning
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Best performance is obtained with ambient
temperature between +18°C and +43°C (class T);
+18°C and +38°C (class ST); +16°C and +32°C
(class N); +10°C and +32°C (class SN).
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
Important
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not
earthed. connect the appliance to a separate
earth in compliance with current regulations,
consulting a specialist technician.
The Manufacturer
responsibility
precautions are not observed.
Attention!
It must be possible to disconnect the appliance from the mains power supply; the plug must
therefore be easily accessible after installation.
This appliance complies with the following E.E.C. Directives:
- 87/308 EEC of 2/6/87 relative to radio
interference suppression.
- 73/23 EEC of 19.2.73 (Low Voltage
Directive) and subsequent modifications.
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
Building in the appliance under a worktop
Dimensions of the recess
The dimensions of the recessed installation area
must correspond with those indicated in the figure.
DO013
declines
if the above safety
The class of your appliance is shown on its
rating plate.
For building-in and door reversibility refer to the
relevant instructions.
Grid preparation
Left door opening:
Remove the left side (A) of the grid cutting it from the
rear (see figure).
DO002/2
Right door opening:
Remove the right side (B) of the grid cutting it from
the rear (see figure).
all
To position the grid on the appliance proceed as follows:
Apply the grid to the base of the appliance by
pushing on to the clasps (a) until they click.
DO001
Installation kit
1xA
1
A
B
a
a
1xB
1xK
2xC
18xI
23