MAC TOOLS MB188UC Manual De Instrucciones página 3

Instructions
UTILITY CARTS and ACCESSORIES
SAVE THESE INSTRUCTIONS
Read all instructions before use.
Wear proper eye protection.
Use protective gloves.
Do not open more than one loaded drawer at one time.
Do not step in or on any drawer or available ledge.
Close lid and lock drawers before moving the unit.
Apply brake on all casters when cart is left in a stationary
position.
Do not place or mount any apparatus on top of the unit
approved for use. All approved accessories and attachments
are listed in the accessories section of this manual.
Replace damaged hinges or ball bearing slides immediately
with o cial manufacturers replacement.
Improper installation of drawers and slides can lead to
injury.
Make sure drawer stops are fully engaged and working
correctly.
Introduction
mobile storage unit, follow the care and operation
instructions as outlined in this manual. This manual will
outline care and operation of your new cart and will also
provide instructions for the attachment of accessories and
extended storage modules.
PN# 080106
TO REDUCE THE RISK OF INJURY
MB188UC / MB188UCFD / MB199UC / MB199UCFD
Lubrication
Slides - The MB199UC class of carts come standard with ball
bearing slides which do not require periodic lubrication and
should be maintenance free.
Locking Mechanisms – Periodically apply prescribed
lubrication to locks and lock mechanisms as needed. Key Lock
(graphite lock lubricant), Lock Lever (light grease or oil).
Casters – The casters on the MB199UC class of carts are
maintenance free. No lubrication access on swivel or wheel.
Wheel has oil impregnated bushing which sits in a delrin
bushing. This creates a very long lasting smooth wear surface.
Drawers with Ball Bearing Slides
Improper drawer removal or installation
may result in injury or damage to drawer
To remove a drawer, follow these steps
1. Empty all contents from drawer.
2. Pull drawer out to its full extended length.
3. Find the lever on the side of the drawer slides.
On the right hand slide PUSH DOWN the lever,
simultaneously PULL UP the lever on the left
hand slide and pull the drawer out over the stops.
4. The drawer can now be fully removed.
To install a drawer, follow these steps
1. Pull the slides out to their full extended position.
2. Align the slides with the runners on the drawer and
push the drawer in keeping it level and even. It will
require some force over the last several inches to
and required to realign the ball bearings correctly.
UTILITY CARTS and ACCESSORIES
®
1
- MANUAL - REV 4.0 - 2014