Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Introduction
Congratulations on your purchase of another fine wireless product
from
Phonic. The W5 digital wireless audio systems are small,
compact units that can securely send your audio signal up to 100
meters without fear of noise, hum or interference present in UHF
systems. Each W5 system consists of a transmitter unit – featur-
ing RCA and USB audio inputs – and one or two receiver units
– each of which has RCA and Optical S/PDIF outputs. Receiver
units feature built-in rechargeable Lithium-ion batteries which
can last up to 3 hours of continuous use. Using 2.4 GHz spread
spectrum modulation technology, the W5 systems revolutionize
wireless audio as we know it.
Features
●
Starter kit offering a single transmitter unit and two stereo
receivers
●
High quality audio achieved through 2.4 GHz uncompressed
PCM transmission
●
Varied inputs and outputs, including USB 2.0, S/PDIF and
RCA
●
900mAH Li-ion battery embedded into receiver with a life up
to 3 hours
●
Supports multiport link: one transmitter can link with up to 5
receivers
●
Provides 16-bit audio at sampling rates selectable between
32, 44.1 and 48 kHz
●
Easy system link between transmitter and receiver
Transmitter Unit
1. Stereo RCA Inputs
Connect any consumer-level device to these RCA inputs and you can
wirelessly send the device's signal to the receiver unit.
2. USB Input
Connecting this mini USB connector directly to your computer's USB
port will allow you to send your computer's stereo audio signal wire-
lessly using the W5 system.
3. DC Power Input
Connect the provided DC power adapter to this input and to a nearby
AC power outlet of a suitable voltage.
1
4
2
3
4. Channel Button and Indicator
Pushing this button will swap the signal currently used by the transmit-
ter between the USB and RCA inputs.
5. RF Button and Indicator
Push and hold this button in concert with the receiver unit's RF button
and a wireless link will be established between the two. The blue
LED indicator below the button will flash briefly and then remain on
to show that a connection has been established.
6. Power Button and Indicator
Push and hold this button for 2 seconds to turn the unit on. An active
unit will be accompanied by an illuminated LED (green). Push this
button once again to turn the unit off.
7. Antenna (not pictured)
Located at the side of the transmitter, this threaded connector is
used to attach the provided antenna units to the W5 to increase the
transmission range.
1
2
Receiver Unit
1. Stereo RCA Outputs
These stereo outputs can be used to connect to a range of RCA-
equipped input devices, such as stereo systems, recording devices,
and even the 2-track Return connectors on professional mixers.
2. Optical S/PDIF Output
This TOSlink connector can be used with an optical cable to connect
to external devices with Optical S/PDIF input.
3. DC Power Input
This DC power inlet is used to connect to the provided DC power
adapter. The power adapter is used not only to power the W5 receiver
unit, but also to charge the built-in battery.
6
5
4
3
W5
Tabla de contenido
