Russell Hobbs 18511-56 Instrucciones página 4

21 To add ingredients while the blender is working, remove the cap, pour the new ingredients
through the hole, then replace the cap.
22 Turn the jug about ¼ of a turn anti-clockwise and lift it off the motor unit.
N CRUSHED ICE
23 Start with half to threequarters of a cup of ice, or 4 to 6 cubes, and add 15ml (1 tablespoon) of
fresh cold water.
24 Put the lid on the blender, then turn the speed control to Y for a second or two, and release
it.
25 Check the results, and adjust.
N CARE AND MAINTENANCE
26 Switch the appliance off (0) and unplug it.
27 Wash the removable parts in warm soapy water, rinse well, drain, and air dry.
28 Wipe the outside of the motor unit with a clean damp cloth.
29 Don't put any part of the appliance in a dishwasher.
N BLADE UNIT
30 You may remove the blade unit for cleaning.
31 This is best done with the jug turned upside down.
32 Grip the jug handle with one hand.
33 Grip the bottom of the blade unit with the other hand.
34 Turn the blade unit clockwise till it comes loose from the jug base.
35 Carefully, pull it up and out of the bottom of the jug.
36 Wash the seal and blade unit in warm soapy water, rinse, and air dry.
37 Take great care with the blades – don't handle them directly, use a nylon washing-up brush.
38 Replace the seal round the blade unit.
39 Turn the blade unit upside down, and replace it in the bottom of the jug base.
40 Turn the blade unit anti-clockwise to tighten it.
O USING THE PROCESSOR
41 You may use the processor and disc for cutting/grating for up to 2 minutes. Any other use
should be limited to 1½ minutes. After this, let the motor rest for 2 minutes.
42 Switch the appliance off (0) and unplug it.
43 Fit the spindle to the top of the motor unit.
44 Lower the jug on to the motor unit, then turn the jug clockwise, to lock it in place.
45 Choose the attachment you need.
O WITH THE SUPPORT
46 Use the chopper for pulverizing ingredients.
47 Use the mixer to mix ingredients together.
48 Use the creamer to thicken cream, to beat eggs, and to cream eggs and sugar together.
49 Fit the attachment over the support, and slide it to the bottom.
50 Lower the support into the centre of the jug, over the spindle.
51 Put the ingredients into the jug.
, Don't fill past the max mark.
52 Hold the lid with the tube slightly behind the jug handle, set it on the jug, then turn it
clockwise, to lock the tab into the top of the handle.
53 To add ingredients while the motor is running:
a) lift the pusher out of the tube
b) add the ingredients via the tube
c) replace the pusher
54 To remove the lid, turn it anti-clockwise to unlock it, then lift it off.
4