Black and Decker BDXPA0071 Manual De Instrucciones página 4

2-Pack Photocell Sensor Night Light with USB
WARNING
PLEASE READ AND UNDERSTAND THIS ENTIRE MANUAL BEFORE
ATTEMPTING TO ASSEMBLE, OPERATE OR INSTALL THE FIXTURE.
SAVE THESE INSTRUCTIONS IN A LOCATION CLOSE TO YOUR LIGHT
FIXTURE SO YOU CAN REFER TO THEM AT A LATER TIME.
WARNING
Read all safety information and instructions before installation.
Suitable for indoor, dry locations only. Do NOT use outdoors.
For plug-in installation only.
This is not a toy and is not intended for use by children. For adult use only.
Do NOT immerse in any liquid or allow liquids to come into contact with the unit.
Do not expose to extreme high or low temperatures.
Do not shine directly into eyes.
The light may become hot if used for long periods of time.
LED BULB CANNOT BE REPLACED.
CAUTION :
Please note that changes or modifications of this product that are not expressly approved by
the party responsible for compliance could void the users' authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
:
:
4