PALSON Future 2200 Modo De Empleo página 9

ADJUSTING THE SUCTION POWER
Low suction power: For curtains and delicate fabrics.
Medium suction power: For velvet and fabric carpets and rugs.
High suction power: For thick carpets and flooring.
POWER CORD WINDER
Pull the power cord out to its maximum length, indicated by the yellow mark. Never pull the power cord beyond
the red mark as this may damage the winder. This damage is not covered by the warranty.
WINDING
Press the power cord winding button and guide it into the vacuum cleaner. Hold the power cord to prevent it
from tangling.
TELESCOPING WAND
- The adjustable length wand enables it to be adjusted to each person's height.
- Unlock the coupling by pressing the button in the direction indicated by the arrow.
- Slide the wand to the required length.
- To lock, release the button and listen for the click as it locks in the appropriate setting.
NOZZLE FITTINGS
Floor nozzle: For cleaning carpets and soft surfaces.
Slot nozzle: For vacuuming in corners and slots.
Brush and upholstery nozzle: Remember that the brush and upholstery nozzle is a "two-in-one" device. For
upholstery, use the nozzle without the device. The brush device is located underneath the upholstery nozzle.
AIR INTAKE REGULATOR
Open the air intake regulator located on the hose attachment to adjust the air flow or remove objects stuck to
the nozzle.
FILTERS
This appliance has three filtering systems.
1. Transparent dust collector:
- The traditional bag system has been replaced by a transparent dust collector into which both the large dirt
particles and the tiny particles floating in the air are sucked by an air vortex produced by the high speed of
the air circulating through the appliance.
- The quantity of dust in the container can be readily viewed at any time. The container is also very easy to
empty.
- It is no longer necessary to buy dust bags.
2. Motor protection filter (in the dust container):
When the dust level has reached the MAX mark in the dust container, proceed as follows:
- Detach the dust container (see Figure 1).
Press the button to detach the dust container and pull the container outwards.
- Remove the contents of the dust container (see Figure 2).
9