Care And Maintenance - cam SMARTY S332 Manual De Instrucciones

harness "F" is in the correct position before in-
serting it into the right and left elements (fi g. 9).
WARNING: the harness must pass between the
frame and the seat unit as shown in fi g. 9
Make pass the harness into the right and left el-
ements following the sequence from fi g. 9A to
fi g. 9H.
POSITIONING AND FITTING THE BOOSTER
SEAT
• Position the booster seat on the centre of the
chair and make sure that the chair has larg-
er dimensions than those of the booster seat
itself (fi g. 10).
• Adjust the height of the booster seat and
then make pass the backrest locking har-
ness "F" under the chair and lock the buckle
(fi g. 11).
• Pull the end of the harness to tighten it (fi g.
12).
• Make pass the seat unit locking harness at
the back of the chair and lock the buckle (fi g.
13).
• Pull the end of the harness to tighten it (fi g.
14)
WARNING: before using the product, make sure
the booster seat is correctly fi xed on the chair to
prevent it from moving.
FOLDING THE PRODUCT
• Unlock all the safety harnesses.
• Push simultaneously the 2 buttons "A"
placed under the armrests and lower the
backrest at the same time (fi g. 15)
• Push simultaneously the 2 buttons "B"
placed on the booster seat frame and push
downwards the frame at the same time (fi g.
16)
• Once the product is completely folded, en-
gage the seat unit locking harness "F" to
prevent the booster seat from opening again
(fi g. 17)
• Transporting the product is very easy thanks
to the practical carrying handle (fi g. 18).
CAM SMARTY.indd 16 CAM SMARTY.indd 16
FOLDING THE TRAY (optional)
• Please refer to the image shown in fi g. 19;
insert part "N" (placed under the tray) into
the relevant housing "Q".
• Insert parts "R" into the relevant housings
"U".
• Use the seat unit locking harness "F" to lock
the tray to the product (fi g. 20).
Transporting the product is very easy thanks to
the practical carrying handle (fi g. 21).

CARE AND MAINTENANCE

Prolonged exposure to the sun and inadequate
washing can cause the colours to change. Lim-
it exposure if possible. Dry all metal parts should
they get wet or damp.
Never leave the product near any source of
strong heat (electrical heating or gas heating) to
avoid fi re danger.
Clean the product with a damp cloth or sponge
and mild detergent. Do not use abrasive or
bleach.
THIS PRODUCT COMPLIES
WITH SAFETY REQUIREMENTS AS PER X PS
54-041
4-12-2007 16:15:32 4-12-2007 16:15:32