Introduction Thank you for purchasing the Ubiquiti Networks® airMAX® Bullet AC IP67. This Quick Start Guide is designed to guide ™ you through installation and includes the warranty terms. Package Contents Bullet AC IP67 N-Type Right Angle Adapter...
Installation Requirements • Shielded Category 5 (or above) cabling with drain wire should be used for all outdoor wired Ethernet connections and should be grounded through the AC ground of the PoE. We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrial-grade, shielded Ethernet cable from Ubiquiti Networks.
Hardware Installation 1. Unscrew the Cable Gland Body and detach it from the Bullet AC Radio. 2. Unscrew the Compression Nut and remove the Compression Seal from the Cable Gland Body.
Página 6
3. Slide the Compression Nut over the Ethernet cable with the threaded end facing the RJ-45 connector. Slip the Compression Seal around the cable. 4. Feed the Ethernet cable through the Cable Gland Body and seat the Compression Seal into the Cable Gland Body. 5.
Página 7
6. Securely screw the Cable Gland Body into the Bullet AC Radio so that the Rubber Washer seals the bottom of the radio. 7. Tightly screw on the Compression Nut. Ensure the Compression Seal is securely compressed and tightly sealed around the cable.
Página 8
8. Connect the Bullet to the N-Type connector of the antenna. Note: The Bullet should be mounted vertically to reduce stress on the N-Type Connector. The N-Type Right Angle Adapter may be used as needed.
Accessing airOS via Wi-Fi Verify connectivity in the airOS® Configuration Interface. There are two methods, the UNMS App and Web Portal. Both ™ are available for 15 minutes immediately after you power on the device. If necessary, you can power cycle the Bullet AC to re-enable its Wi-Fi.
Página 10
5. Tap Connect on the Login screen. Bullet AC IP67 192.168.172.1 BulletAC-IP67: F08FC2552018 6. Select your Country and tap Done. United Kingdom Argentina Armenia Aruba Australia Austria Azerbaijan Bahrain Barbados Belarus Note: For the Country setting, U.S. product versions are restricted to a choice of Canada, Puerto Rico, or the U.S.
Página 11
7. Under Configuration, customize your settings as needed. Bullet AC IP67 (Not Applicable)
Página 12
Web Portal 1. Connect your device’s Wi‑Fi connection to the Bullet AC SSID named: BulletAC-IP67:<MAC Address> Note: Ensure that your Wi-Fi connection has DHCP enabled. 2. Launch a web browser and go to: http://setup.ubnt.com http://setup.ubnt.com 3. Enter ubnt in the Username and Password fields. Select your Country and Language.
Página 13
Installer Compliance Responsibility Devices must be professionally installed and it is the professional installer’s responsibility to make sure the device is operated within local country regulatory requirements. Antenna Select your antenna from the list. If Calculate EIRP Limit is enabled, transmit output power is automatically adjusted to comply with the regulations of the applicable country.
Página 14
Specifications BulletAC-IP67 Dimensions 190 x 46 mm (7.72 x 1.81") Weight 213 g (7.51 oz) Enclosure Aluminum and Rubber Processor MIPS 74KC Memory DDR2 64MB Networking Interface (1) 10/100/1000 Ethernet Port Antenna Connector N-Type Connector Max. Power Consumption Max. TX Power 21 dBm Power Supply* 24VDC, 0.3A (Minimum)
Safety Notices Read, follow, and keep these instructions. Heed all warnings. Only use attachments/accessories specified by the manufacturer. WARNING: Do not use this product in a location that can be submerged by water. WARNING: Avoid using this product during an electrical storm.
Página 16
Compliance Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation.
Página 17
IMPORTANT NOTE: Radiation Exposure Statement: • This equipment complies with radiation exposure limits set forth for an uncontrolled environment. • This equipment should be installed and operated with minimum distance 20 cm between the radiator and your body. • This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Página 18
CE Marking CE marking on this product represents the product is in compliance with all directives that are applicable to it. Country List AT BE BG CY CZ DE DK EE EL ES FR HR LU MT NL PL PT RO BFWA (Broadband Fixed Wireless Access) members noted in blue Note: This device meets Max.
Página 19
RoHS/WEEE Compliance Statement English European Directive 2012/19/EU requires that the equipment bearing this symbol on the product and/or its packaging must not be disposed of with unsorted municipal waste. The symbol indicates that this product should be disposed of separately from regular household waste streams.
Página 20
Español La Directiva 2012/19/UE exige que los equipos que lleven este símbolo en el propio aparato y/o en su embalaje no deben eliminarse junto con otros residuos urbanos no seleccionados. El símbolo indica que el producto en cuestión debe separarse de los residuos domésticos convencionales con vistas a su eliminación.
Íslenska [Icelandic] Hér með lýsir UBIQUITI NETWORKS yfir því að BulletAC-IP67 er í samræmi við grunnkröfur og aðrar kröfur, sem gerðar eru í tilskipun 2014/53/EU. Fullur texti ESB samræmisyfirlýsing er að finna á eftirfarandi netfangi: www.ubnt.com/compliance...