Raider RDI-IBW02 Manual Del Usuario página 12

12 www.raider.bg
cleaning.
1.6.11. Disconnect the charger from mains network when it is not in use.
2. Construction and use.
Impact wrench is a battery-powered tool. Drive consists of DC commutator motor with
permanent magnets and planetary gear. Impact wrench is designed for screwing in and out
screws and bolts in wood, metal and plastics and for drilling holes in these materials. Cordless,
battery-powered power tools are especially useful for works in interior furnishing, adaptation of
premises etc.
Use the power tool according to the manufacturer's instructions only.
3. Noise level and vibration parameters.
Sound pressure: Lp
Vibration acceleration: a
4. Preparation for operation.
4.1. Inserting and removing the battery.
Set the rotational direction switch to the center position to protect the power tool against
accidental starting. Insert the charged battery into the handle so that it can be felt to engage
and faces flush against the handle.
4.1.1. Remove the battery pack from the handle by pressing the battery lock button downwards
and pulling the battery forwards and off the base of the tool.
4.1.2. Check if the power voltage on the rating plate corresponds to the voltage available.
4.1.3. Slide the battery pack onto the battery charger . The red LED will illuminate to indicate
that
the battery pack is being charged. When the charging process is finished, the red LED on
the charging base will turn off and the green LED will illuminate. It takes approximately 1 hour
to fully recharge an empty battery.
4.1.4. During charging, it is normal for the battery to warm slightly. If you cannot discharge the
battery check:
- That the electrical outlet has voltage.
- That the charger contacts are undamaged and making contact with battery leads.
- If the battery still fails to charge, please contact our customer service department.
4.2. Charging the battery.
Impact wrench is supplied with partially charged battery. Charge the battery full before use.
Charging the battery should be carried out in temperature between 4°C to 40°C. New battery,
or one that have not been used for a long time, will reach full efficiency after approximately 5
charge/discharge cycles.
The mains voltage must match the voltage on the charger rating plate.
Always check technical condition of the charger, charging station and power cord before
starting to charge.
When charging the battery, use only the charger and the charging station supplied with the
impact wrench.
Do not expose the charger and charging station to rain or splashing.
BATTERY CAPACITY INDICATOR
You can check the battery's power status by pressing the power display button on rear of the
battery.
- All LEDs illuminated: The battery is fully charged.
- Yellow and red LED illuminated: The battery has an adequate remaining charge.
- Red LED: The battery is empty, recharge the battery.
USB Power Port
You can power any portable device that uses a USB power port . The output is 5 volts at 1.5 mA
maximum output. You cannot charge the battery using this port, it is for output power only.
Charging port
= 99,3 dB(A); LwA=110,3 dB(A);
A
= 22,35 m/s .
2
h