Top Panel - Up-Tr1; Back Panel - Up-Tr1 - Onkyo UP-TR1 Manual De Instrucciones

Top panel - UP-TR1

1 23
a
 ON/STANDBY button
Press to turn the device on, then hold to initiate pairing. Press
again to go to standby.
b
ON/STANDBY indicator
Lights blue when HUB STATUS is set to DISABLE.
Lights green when HUB STATUS is set to ENABLE.
Lights steady when the sender/receiver is paired to a network.
Blinks slowly when the sender/receiver is not paired to a network.
Blinks quickly when the sender/receiver is in pairing mode.
c
Standby indicator
Lights red when the sender/receiver is in standby mode.
d
TX1, TX2, TX3 sending mode indicators
Lights blue when the sender setup is ON. The indicator that
lights and the receiver's display show the following.
indicator Receiver's indicator
TX1(ZONE2)
TX1
TX1(FRONT)
TX2(SB/FH)
TX2(SURRBK)
TX2
TX2(SURR)
TX2()
4
En-
4 5 6
Explanation
Zone 2 channels are output
Front channels are output
Surround Back or Front High chan-
nels are output
SurBack channels are output
Surround channels are output
No sound is output
indicator Receiver's indicator
TX3 TX3(SUBW)
e
SOURCE button
Press to move to the next receiving source. Each press toggles to
the next source.
f
Rx - Receiver mode indicator
Lights blue when receiving signals.

Back panel - UP-TR1

1 2
DISABLE ENABLE
HUB STATUS
a
External antenna
Receives signals from other Rocketboost™ senders.
Sends signals to other Rocketboost™ receivers.
b
HUB STATUS switch
Enables/disables hub mode operation. See "Establishing com-
munications" for additional information.
When hub status is enabled, the device is on even when the
receiver is in standby mode.
When hub status is disabled, the device is off when the receiver
is in standby mode.
Note:
In a Rocketboost™ network, only one Rocketboost™ device
should have the Hub Status switch set to ENABLE.
Explanation
Subwoofer channel connected to
the rear panel SUBWOOFER OUT
jack is output
3 4 1
IN
SUBWOOFER