ELICA Majestic Sense Manual De Instrucciones página 26

Automatic operation (sensor)
Press the button
in white).
The hood will switch on at the most suitable speed based on
the cooking fumes detected by the sensor on the hood.
Automatic operation of the hood with SNAP
Press the button
orange) to indicate that the hood can operate automatically
®
with the SNAP
®
Note: SNAP is an auxiliary suction unit that can operate
together with the hood. For further information, please consult
the manual supplied with SNAP
Automatic operation of the hood with the Elica hob
Operation of the hood will also depend on use of the Elica
hob.
Press the button .(the LEDs
to indicate that the hood can automatically operate with the
Elica hob; thus, hood operation will also depend on use of the
Elica hob.
Note: Automatic operation with the hob is possible only with
specific cooking hobs; for further details, please contact the
authorised dealer or technical assistance centre.
Automatic operation of the hood with SNAP
hob
Press the button
orange) to indicate that the hood can operate automatically
with the hob and the SNAP
Setting of parameters for Automatic Operation
Note: All calibration, selection, setting and logical
connection operations described below can be performed
with the hood off (OFF).
The adjustment of parameters is regularly done
automatically every time the hood is reconnected to the
mains (e.g. with the first installation or after a blackout) or
manually.
Manual setting
To be performed when you notice unsatisfactory
functioning of the Automatic operation, and is done when
normal environmental conditions persist in the kitchen.
Manual setting includes:
• Hood calibration
• Selection of hob (gas, induction, or electric)
• Logical connection between the hood and the hob (if
you have an Elica hob).
• Logical connection between the hood and SNAP
you have SNAP
.(the central LED
®
.(the LEDs light up in
®
light up in white)
®
.(the LEDs light up in
®
®
).
Hood calibration
lights up
Selection of the hob (gas , induction, or electric)
Logical connection between the hood and the hob (if
you have an Elica hob).
and Elica
If an Elica hob is NOT mounted:
In this case the hood, after being connected to the mains
power supply, will nonetheless attempt to connect to a hob:
the hood will emit 2 beeps intermittently for roughly 5 minutes.
Wait for the hood to terminate the connection attempts then
proceed with deactivation of the electronic connection
module as described below:
With the hood switched off, simultaneously press buttons
®
(if
26
Press and hold the button
flash to indicate initiation of calibration; the process
will last for approximately 5 minutes.
Press and hold simultaneously the buttons
and : buttons
start flashing for 5 seconds.
Within this timeframe, press:
button in case of gas hob
button in case of electric hob
button in case of induction hob
The preselected button remains lit to indicate the
selection was performed, after 10 seconds the
button flashes briefly to indicate that the performed
selection was recorded.
a. Simultaneously connect the hood and Elica hob.
b. the hood emits 2 acoustic signals (beeps) to
indicate that it can receive the connection signal
from the Elica hob.
c. the connection attempts with the Elica hob last for
5 minutes; within this time, the hood emits 3
consecutive acoustic signals (beeps) to indicate the
successful connection with the Elica hob.
d. Check the successful connection with the Elica
hob: Press the button
light up in white).
In case the logical connection between the hood
and Elica hob is not successful, proceed as
indicated below:
Disconnect and reconnect the hood from/to the
mains at least 5 times within 30 seconds.
Repeat the operations a-b-c-d described above
, all button LEDs
, and
.(the LEDs