First Time Use; Cleaning And Maintenance - Duronic MG1600 Manual De Instrucciones

First Time Use

- Check that voltage indicated on the rating label corresponds to the mains
voltage in your home.
- Wash all parts (except body) with warm soapy water.
Instructions for Use
Assembling
- While holding the head, inset it into the inlet
(fig.1). Rotate the head in the same direction as
fig.2 until a click can be heard. Move the head
slightly to ensure it is placed in securely.
- Place the feed screw into the head (long end
first) by turning the feed screw until it is set into
the motor housing (fig.3).
- Place the cutting blade onto the feed screw
shaft with the blade facing the front as
illustrated (fig.4). If it is not fitted properly, meat
will not be ground.
- Place the desired cutting plate next to the
cutting blade, fitting protrusions in the slots
(fig.5).
- Support or press the centre of the cutting plate with one finger then screw
the fixing ring until tight with the other hand (fig.6). Do not over tighten.
- Place the hopper plate on the head and fix into position.
- Place the unit on a flat, non slip surface.
- The air passage at the bottom and the side of the motor housing should be
kept free and not blocked.
8
Mincing Meat
- Cut all food into pieces (boneless and fatless meat is recommended, approx
20mm x 20mm x 60mm) so that they fit easily into the hopper opening.
- Plug in and press the ON/OFF button to turn on the machine.
- Feed food into the hopper plate. Only use the food pusher (fig.7)
- After use, switch the unit off and unplug it from the power supply.
Reverse Function
- In case of jamming, switch the appliance off by pressing the 'ON/OFF'
button and press the "REV" button.
- Feed screw will rotate in the opposite direction and the head will become
empty.
- If it doesn't work, switch the unit off and clean it.

Cleaning and Maintenance

Disassembling
- Make sure that the motor has stopped completely.
- Disconnect the plug from the power outlet.
- Disassemble by reversing the steps from images 6-1.
- If the fixing ring is not easily removed by hand, please use tools in fig 12.
- To remove the cutting plate easily, place a screwdriver between the cutting
plate and the head as illustrated and lift it up (fig.13).
- Press the unlock button before removing the head. Holding the head, rotate
it in the same direction as fig. 14. The head can then be removed easily.
9