Tabla de contenido
Idiomas disponibles
Idiomas disponibles
V. Operating Instructions
Function
The Fixed Shade Welding Helmet is designed to protect the eyes and face from
sparks, splatter, and harmful radiation under normal welding conditions.
Before Welding
The Fixed Shade Welding Helmet comes ready for
use. The only things you need to do before welding are
to
•
remove the protective film from both sides of
the lens (if not already done),
•
adjust the position of the headband, and
•
Check the Front Cover Lens to make sure
that It Is clean.
•
Also check the Front/Inside Cover Lens and
the Front Lens Retaining Frame, and make
sure that they are secured in place.
Inspect all operating parts before each use for signs of wear or damage. Any
scratched, cracked, or pitted parts should be replaced immediately before using
again to avoid severe personal injury.
Adjusting Headband
Adjust the Headband so that the helmet is seated
securely on your head as low as possible and
close to your face.
Adjust the Headband width by turning the
Ratcheting Headband Knob to make sure the
Front Cover Lens is aligned with your eyes.
Adjust the Headband height by tightening or
loosening the top strap until the Helmet fits snug
on your head.
Once the Headband is properly adjusted, lower
the Helmet over your face until the proper angle
is found. Then turn the Tension Adjustment
Knobs on either side of the helmet, locking the
helmet's angle in place.
Filters
The ultra high performance of UV and IR filters provides to user's eyes and face full
protection against UV and IR radiation during entire welding process, The UV/IR protection
level is up to shade 11 at all times.
4
Figure C
Tabla de contenido
Solución de problemas
