Cold Lamination; Other Information - PAVO II Manual De Instrucciones

Open pouch and place contents face-up toward the non adhesive side. Insert the sealed edge first into
the machine. For best results remove the edge of the protective sheet that is closest to the machine
entrance, as the machine draws the pouch through pull back the sheet at the same rate.
You can entirely remove the protective sheet before placing in the machine; this technique increases
the probability of air bubbles.
If for some reason your pouch jams you can either use the Reverse Switch (A3 / 15" Machine) or
press down on the Lever at the back of the machine (A4/9" Machine), this separates the rollers
allowing the pouch to be pulled free.
Laminating:
When laminating both hot and cold pouches we recommend that you leave minimum margin of
3mm / ⅛ inch around the edge. If Laminating several object leave a space of 6mm / ¼ inch between
objects.
If you need to cut a pouch do so after laminating. Cut pouches can leak glue in to your machine.
Pouches are also easier to cut accurately when laminated.
A. If your pouch is not sealed, temperature is either too cold or there is not a big enough margin.
B. If your pouch is cloudy the temperature is too low or the pouch to full.
C. If your pouch is wavy the temperature is too hot.
D. If there are spots on the pouch. Glue has seeped from pouches on to rollers. Run a sheet of
paper through.....continue until clear.
E. If your pouch has wrapped around rollers.....Remove using Jam Release / Rev. Clean rollers
with a plain sheet of paper (preferably 120gsm or thicker).
The machine has a warranty of 2 years (the warranty is not applicable if the pouches has been
inserted in the wrong position/direction, or the machines has been used for an inappropriate
purpose).
Voltage....................................................................................................................220-240V
Power consumption.................................................................................................350W
Max width laminating .............................................................................................230mm/9''
Max thickness laminating .......................................................................................2x125mic
Dimension ...............................................................................................................39 x 11 x 19 cm
Weight.....................................................................................................................1,5 KGS
C L
OLD AMINATION
O I
THER NFORMATION
T
ROUBLESHOOTING
W
ARRANTY
T D
ECHNICAL ATA
4