4. When mortar layer is dry, perform
necessary waterproofing (Liquid /Fabric
Waterproofing) as per local code. Ensure
waterproofing layer reaches the edge of
the hole in the drain body (C2).
4
Backer Board
(C2) Bonded Flange
Drain Body
5. Set top threaded ring (C1) onto the bonded
flange drain body (C2) using thinset and
position to desired location within the drain
body (C2).
Note: When overall build up greater
than ¼" above waterproofing is needed
(excluding finished floor material thickness)
use mortar to set top threaded ring (C1).
6. Once the thinset/mortar is dry, thread
the throat (B) into top threaded ring (C1).
Adjust to the desired height. Turn clockwise
to lower, counter-clockwise to raise.
When determining desired height, include
thickness of thinset and finishing material.
6
Bonded Flange
Drain Body
Model
Overall Minimum Height
LTD 5 B
1"
RTDB 15
¹³⁄
TDB 15
1 ⁵⁄
TDB 20
1 ⁵⁄
Subfloor
Liquid/Fabric
Waterproofing
Motar Bed
Waste Line Pipe
(C1)
(C2)
"
¹⁶
"
¹⁶
"
¹⁶
4. Cuando el mortero este seco, realice
necesario impermeabilización (Liquida/
Tela impermeabilización) según las
normas locales. Asegure que la capa de
impermeabilización alcance el borde del
agujero en el cuerpo del desagüe (C2).
5
(C1) Top Threaded
Ring
(C2) Bonded
Flange
Drain Body
Waste Line Pipe
5. Fijar la parte superior roscada (C1) en el
bonded flange desagüe (C2) usando thinset y
posiciónelo a la ubicación deseada dentro del
desagüe (C2).
Tenga en cuenta: Cuando construya más que
¼" arriba impermeabilización es necesaria
(excluyendo material de piso terminado)
Utilice mortero para fijar el anillo roscado.
6. Una vez el thinset/mortero este seco, rosca
el cuello (B) en la parte superior del anillo
roscado (C1). Ajustar a la altura deseada. Gire
hacia la derecha para bajar, hacia la izquierda
para subir. Cuando determine la altura, incluya
espesor del thinset y material terminado.
(B) Throat
Waste Line Pipe
Overall Maximum Height*
2"
1 ⁷⁄
"
¹⁶
1 ¹⁵⁄
"
¹⁶
2 ¹⁄
"
¹⁶
4
Liquid/Fabric
Waterproofing
Thinset/Motar
Motar Bed