Charging The Battery Pack - Toro PowerPlex 88525 Manual Del Usuario

Operation

Charging the Battery Pack

Important:
The battery pack is not fully charged
when it is purchased. Before using the tool for the
first time, place the battery pack in the charger
and charge it until the LED display indicates the
battery pack is fully charged. Make sure to read
all safety precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1. Plug the power cord that matches your power
outlets into the battery charger.
2. Make sure that the vents on the battery are clear
of any dust and debris.
3. Line up the cavity in the battery pack
with the tongue on the charger.
Model 88525
1. Battery pack cavity
2. Battery pack terminals
3. Battery pack venting areas
6).
(Figure
Figure 2
4. Battery-charge-indicator
button
5. LED indicators (current
charge)
1. Battery pack cavity
2. Battery pack terminals
3. Battery pack venting areas 7. Flashlight
2)
4. Battery-charge-indicator
button
Note:
Quickly press the
battery-charge-indicator button twice to turn the
flashlight on or off (battery pack Model 88526
only). The flashlight automatically shuts off after
approximately 60 minutes of use.
Note:
The USB port is provided for your
convenience to charge most small electronics,
such as your cell phone or tablet (battery pack
Model 88526 only).
4. Make sure that the vents on the battery charger
are clear of any dust and debris.
5. Slide the battery pack into the charger until it is
g228487
fully seated
7
Figure 3
Model 88526
5. LED indicators (current
charge)
6. Handle
8. USB port (not shown;
located under handle)
(Figure 4).
g228488