HIKVISION DS-PD2-P10P-W Guia De Inicio Rapido

DS-PD2-P10P-W
Wireless 10m Pet Immune PIR Detector EN50131-2-2:2008
EN50131-1:2006+A1:2009
Environmental Class (EC) II
Security Grade (SG) 2
E N G L I S H
Diagram References
1 Wireless device control
2 Registration
Please register the detector within 90 seconds after it being powered on.
Register Locally
1. Make the security control panel enter the registration mode.
2. Register the detector: Hold the registration key until the three LEDs flash
alternately.The green LED will flash 8 times if the registration is finished.
3. Communication Test: Release the TAMPER spring to trigger the alarm.
Note: The distance between the security control panel and the detector
should be less than 50 cm.
Initialize the Detector
1.Remove the battery to power the detector off.
2. 5s later,hold the registration key and reinstall the battery to power the
detector on at the same time to make the three LEDs start flashing alternately.
Release the registration key while the three LEDs flash once together.
3 Diagnostics(Check Signal Strength Before Mounting)
4
Wired Tamper and Brackets
Specification
Lens Characteristics
Detection Range 10m
Detection Angle 85°
Detection Zones 56 zones and 6 planes
Detection Speed 0.3–3.0 m/s
Mounting Height 1.8-2.4m
Key Features
Animal Immunity 24kg
Blue Wave Technology Yes
Digital Temperature Compensation Yes
Tamper Protection Front, rear, and bracket tamper signal input
Signal Strength Indicators (SSI) Yes
Electrical & Battery
Transmission Frequency 868MHz, FM transceiver
Range in Open Space 800m
3V Lithium Battery Included 1x CR123A
Minimum Battery Life (years) 2
Environment Features
Operation Temperature -10°C to +40°C(Certified)
Weight 125g
Dimensions(H x W x D) 117 x 69 x 50mm
Accessories
Ceiling Mounted Bracket Included Yes
Wall Mounted Bracket Included Yes
Battery Information
The batteries supplied have been chosen to provide long service life
whilst, for safety reasons, having limited output current.The battery is
protected on purchase by a piece of plastic that must be removed for
operation. When disposing of the product, the battery must be removed
and disposed of separately in accordance with the local regulations.
This product and - if applicable - the supplied accessories too are
marked with "CE" and comply therefore with the applicable harmonized
European standards listed under the RE Directive 2014/53/EU,
the RoHS Directive 2011/65/EU.
For electrical products sold within the European
Community. At the end of the electrical products
life, it should not be disposed of with household
waste. Please recycle where facilities exist. Check
with your local Authority or retailer for recycling
advice in your country.
1
HIGH
+ +
+ +
LOW
+ +
+ +
2
3
5s
+
-
4
Hangzhou Hikvision Digital Technology CO.,Ltd.
TAMPER
LED ON LED OFF
HIGH
LOW
REGISTRATION
+
-
>5s
<24kg
>24kg
A C
WALLBRACKET
B
D
No.555 Qianmo Road, Binjiang District, Hangzhou 310052, China
CR123A
LITHIUM
-
BRACKET TAMPER
SEE SECTION4
+
-
+
-
REAR TAMPER
BREAK-OUT 10m
<24kg
2.4m
E
A
=
=
REGISTRATION
HORIZONTAL COVERAGE
85 °
56 ZONES
9m
6 PLANES
8m
7m
6m
5m
4m
3m
2m
1m
10m
1m 2m 3m 4m 5m 6m 7m 8m 9m
VERTICAL COVERAGE
10m
1m 2m 3m 4m 5m 6m 7m 8m 9m
CEILINGBRACKET
C
B