König KNLEDFLST30W Manual De Instalación Y Funcionamiento

Specifications
Art No. KNLEDFLST30W
Power : 30 W
Input voltage 220...240 V (AC)
luminous flux 2300 lm
Colour temperature 4000 K
LED Lifetime 20.000 hours
Beam angle : 120°
Dimensions 335 x 302 x 213 mm
Degree of protec- IP54
tion (IP)
Connection cable 5 m, H07RNF2x1,0 mm²
General safety instructions
Please read the operating instructions for the LED
luminaire before use. The operating instructions are
part of the product. They contain important notes
on start-up and handling of the device. Always
keep the enclosed operating instructions so as to be
able to look up information. They must be enclosed
when passing the device on to third parties.
Safety precautions
The user must observe the safety notes and
warnings in order to maintain this status and to
ensure safe operation. Please read the operating
instructions before start up. Never attempt to open the device other than
described in this manual. The LED luminaire
cannot be repaired; this part must be immediately
disposed in case of a defect. Ensure sufficient
ventilation of the device. Never cover it during
operation. Do not install in reach of children or
animals. Any other use of the device than described
above can damage the product or endanger the
user due to e. g. short-circuits, fire or an electric
shock. The entire product may not be modified or
adapted.
Installation and Operating Manual
These safety notes must be observed in all cases!
KNLEDFLST50W
Any warranty claim is void in the case of damages
caused by non-observance of these operating
50 W
instructions. We are not liable for consequential
220...240 V (AC)
damages or for damages to property or persons
caused by non-observance of the safety notes
4000 lm
and improper operation of the device.
4000 K
Note: The LED floodlight with carrier can be adjusted
20.000 hours
continuously within the swivelling range.
120°
Safety notes
335 x 302 x 213 mm
LED-lights are extremely bright. Under no circumstances
IP54
look into the light beam of the LED
lights, as this may cause permanent damage to
your eyes.
5 m, H07RNF2x1,0 mm²
FIRE HAZARD! Fit the light
so that it is at least 1 m away
from the material to be
illuminated. Excessive heat
can result in a fire.
If the glass is broken, it has to
be replaced with a new original
protective glass before
further use.
RISK OF INJURY FROM BURNS! Ensure the light
has been switched off and allowed to cool before
you touch it.
„To prevent hazards, a damaged flexible outer
lead of this light may only be exchanged by
the manufacturer, his service representative or
by an equally qualified specialist.
Note: Please ensure that the LED floodlight
stands safely and on a firm surface. Please ensure
that the cable is not getting squashed or
otherwise damaged.
1
English