Tabla de contenido
Idiomas disponibles
Idiomas disponibles
FITTING THE BATTERIES.
This monitor uses two 1.5 volt R6 AA
ALKALINE BATTERIES. To fit the
batteries, remove the rear cover on
the monitor, Fig.1, and carefully insert
the two "R-6 AA" type batteries into
the battery compartment (A) making
sure that the battery's polarity is
correct (matching the battery's «+»
terminal with the «+» sign inside the
battery compartment, and the «-»
terminal with the «-» sign).
Close the cover, as shown in Fig.1.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
The monitor will switch itself off
automatically
if
motionless for 3 minutes.
Important. Discarded batteries must
be deposited in special containers,
Fig.2.
FITTING THE ELECTRONIC
MONITOR.-
Take the monitor (1) and remove the
four screws (4) from the base of the
monitor, Fig.1, connect the terminals
for the feedback cables (54a-55a)
coming out of the monitor to the cable
(54-55)
sticking
handlebar stem, Fig.3, then plug the
terminal (36) which is also sticking out
of the handlebar stem into the hole
(36a) on the base of the monitor,
position the monitor on the handlebar
English
the
unit
remains
up
out
of
stem, making sure not to catch any of
the cables, and attach it using the four
screws (4) removed previously.
ELECTRONIC MONITOR.-
To give you greater control over the
exercise, this electronic unit provides
simultaneous
distance, exercise time, calories burnt
and pulse rate.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key.
The monitor will switch itself off
automatically if the unit stands idle for
more than 3 minutes.
A.SCAN FUNCTION.-
In
SCAN
continuously scans and displays all of
the functions during exercise. The
function being displayed will flash on
and off.
To select the SCAN function:
1. The monitor starts in SCAN mode
as soon as exercise begins or if any
key is pressed, the main screen will
display TIME, SPEED, DISTANCE,
CALORIES, PULSE RATE values
every 6 seconds, this value will also
be displayed flashing on the lower
section of the monitor.
2. Press the MODE key and this will
cancel the SCAN function.
B.TIME FUNCTION.-
This function counts up or down in
the
steps
of
maximum of 99:00 seconds. Pressing
the RESET key for more than two
seconds will reset all of the values,
except those relating to personal
information.
7
read-outs
of
mode
the
one second,
speed,
computer
up to a
Tabla de contenido
