Digital Setup; Special Dvd Functions; Intro Key; Program Mode - LEXIBOOK LCDDVD2BB Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
Tone
Use the▲and▼keys to adjust the tone.

Digital setup

Use the▲and▼keys on the remote control to select "DIGITAL SETUP". Then use the ▲/▼/◄/► keys to select
the menu options.
Note: To exit the menu, select "EXIT SETUP" and press ENTER or press the DVD-SETUP key at any moment.
Dynamic range
When "SPDIF / RAW" is selected, you can set the line out ratio to get a different effect. Use the ▲and▼keys
on the remote control to adjust the settings. If adjusting to "FULL", the audio signal peak volume will be the
minimum; while adjusting to "OFF", the volume will be at its maximum. You can also select "6/8", "4/8" or "2/8".
Dual mono
Use this option to select the audio output type: "STERO", "MONO L", "MONO R" or "MIX MONO".

INTRO key

When listening to an audio CD, press the INTRO key on the remote control to playback the first 15 seconds of
each track.
Note: this function is available only for audio CD.

Program mode

This function is applicable for DVD and CD audio discs. You may assign the playback sequence according to
your preference.
CD/CDG
1. Press the PROGRAM key on the remote control. The program sequence table will be shown on screen.
2. With the numeric keys (0-9) of the remote control, enter the track numbers according to your preference.
3. After assigning the playback sequence, move the highlight cursor to the "PLAY" option by using the
▲/▼/◄/►keys. Press the ENTER or
DVD
1. Press the PROGRAM key on the remote control. The program sequence table will be shown on screen.
2. Enter the title number using the numeric keys.
. Enter the chapter number of the title selected in the last step.
4. Repeat the last 2 steps to input the sequence.
5. After assigning the playback sequence, use the ▲/▼/◄/►keys to select "PLAY". Press the ENTER or
keys to confirm and launch the sequence.
6. To cancel a program, move the cursor to "CLEAR" and press ENTER.
Note: press the PROGRAM key on the remote control at any time to exit the program mode.

Picture CD

1. Insert a picture CD into the tray. If the disc is identified, the player will display a list of the pictures (JPG)
stored on the CD.
2. Use the▲/▼/◄/►keys to select a picture and press the ENTER key to display the image.
. Press the
key to launch/pause/resume a slide show of the pictures.
4. Press the
key to display the next picture. Press the
Note: depending on the files size, it may take a few seconds before the pictures are displayed on the LCD
screen.
5. Press the PROGRAM key to select one of the 17 transition effects for the slide show.
6. You can use the▲/▼/◄/►keys to flip or rotate the pictures.
7. Press the
key to stop the slide show and go back to the photo list.

SPECIAL DVD FUNCTIONS

keys to confirm and launch the sequence.
key to display the previous picture.
25
Tabla de contenido
loading

Tabla de contenido