Safety Information; Troubleshooting - Home Depot 216600 Guía De Uso Y Cuidado

5
MOUNTING THE PUSH BUTTON
□ Remove the front cover from the base by following step 1.
□ Mount the push button base to a clean wall or door jamb
with included #4 screws or mounting tape. If mounting with
screws, predrill a pilot hole through the push button base in
the desired location using a 5/64 in. drill bit.
□ Snap the push button cover onto the base by first hooking
the tops together, then snapping the base on.

Safety Information

You are cautioned that changes or modifications not expressly approved by the party responsible for compliance
could void your authority to operate the equipment.
This Device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Battery Safe Handling:
□ Do Not Mix Old And New Batteries.
□ Do Not Mix Alkaline, Standard (Carbon – Zinc), or Rechargeable (Nickel – Cadmium) Batteries.
□
Battery must be recycled or disposed of properly.
□
Keep battery away from children. If swallowed, promptly see a doctor. Do not open battery, dispose of
in fire, put in backwards, or short circuit—it may ignite, explode, leak or get hot causing injury.
Specifications
Doorbell Type
Number of Push Buttons
Included Hardware
Finished Product Dimensions
Transmission Range
Number of Sounds
Chime Power Source
Push Button Power Source

Troubleshooting

Problem
Chime does not sound when push button is pressed.
Chime is sounding without the push button being pushed.
6
RESYNCING THE CHIME AND PUSH BUTTON
□ Press and hold the learning mode button on the chime until
you hear a ding sound. The chime is now reset and ready to
be resynced.
□ Follow step 3 to sync the chime and push button.
Wireless
1
(2) #4 x ¾ in. Screws, (1) 18x31mm Adhesive Sticker, (1) #6 x ¾ in. Screw, and (1) Wall Anchor
4.79 in. Height x 2.75 in. Width x 1.03 in. Depth
100 ft.
2
(3) AA Batteries (not included)
CR2032 Battery (included)
Possible Cause
Push button battery has not been
activated.
The chime and push button are out
of transmission range.
Push button battery needs to be
replaced.
Chime batteries need to be
replaced.
An outside signal is interfering with
the signal between the chime and
push button.
WARNING: Keep batteries out of reach of
children.
Solution
Confirm the activation tab has been removed and
the battery is seated properly in the button.
Move the chime closer to the push button
location. Ensure there are no metallic objects or
concrete walls hindering the signal.
Replace the push button battery with a CR2032
Lithium Coin battery.
Replace the chime batteries with (3) AA batteries.
Resync the chime and push button following the
steps in the instructions.
Please contact 1-855-556-1852 for further assistance.
HOMEDEPOT.COM