Enlaces rápidos
Handshower with 24" Standard Slide Bar
Ducha de mano deslizable con barra estándar de 24"
Douche à main avec barre coulissante standard de 24 po (61 cm)
• Tools Required/Outils Requis/Herramientas Necesarias:
Flathead Screwdriver/Tournevis á lame plate/Destornillador chato
Phillips Screwdriver/Tournevis Phillips/Destornillador cruciforme
Marking Pencil/Marqueur/Lápiz marcador
Level/Niveau/Nivel
Drill/Perceuse/Taladro
¼" Drill Bit/Barrena de ¼"/Foret de ¼ po (0,6 cm)
• Hardware Provided/Petit matériel de fixation fourni/Se incluye los herrajes:
Mounting Screw/Vis de fixation/Tornillo de montaje
Plastic Anchor/Vis d'ancrage en plastique/Sujetador de plástico
Plumber's tape/Ruban pour tuyau/Cinta de plomero
Hex wrench/Clé hexagonale/Llave hexagonal
• Installation Steps:
This product is packaged partially assembled. You will need to take some
components apart to install.
INSTALL TOP SLIDE BAR POST
1. Remove base from slide bar posts (Fig 1).
2. Locate where you want to install the slide bar. Use the post as a template
and mark locations on shower wall using pencil (Fig 2).
3. Using the drill bit, carefully drill four holes.
TIP: INSTALL ONE POST, THEN ASSEMBLE SLIDE BAR AND CONFIRM HOLE
POSITION OF SECOND POST BEFORE DRILLING (Fig 3).
4. Insert the plastic wall anchors into the four holes. You may need to tap
them lightly into position with a hammer (Fig 4).
5. Secure post with mounting screws provided (Fig 5).
6. Slide the base back onto the post; it should "click" into place. Tighten the
set screw with supplied hex wrench (Fig 6).
INSTALL BOTTOM POST AND SLIDE BAR
7. Place and hold the bar into top post, making sure the notch in the post alighs
with the groove in the bar. Repeat step 5-6 for bottom of post (Fig 7).
NOTE: Water can be p
showerarm, showerarm diverter (D481350
• Pasos para la instalación:
Este producto está parcialmente ensamblado. La instalación requiere el
desemsamblaje de algunos componentes.
rovided to the handshower through a Danze
) or supply elbow (D469058).
I N S T A L L A T I O N
D465005 D465007 D461800
Post/
montante/
fixation
Drill/Taladro/Perceuse
Base/
Base/
Base
Slide bar/
Barra/
Barre coulissante
Slide body/
Pieza deslizante/
Support coulissant
Fig 1
Fig 2
Drill bit/Barrena/Foret
Fig 3
Manuales relacionados para Danze D465005
Resumen de contenidos para Danze D465005
- Página 1 7. Place and hold the bar into top post, making sure the notch in the post alighs with the groove in the bar. Repeat step 5-6 for bottom of post (Fig 7). NOTE: Water can be p rovided to the handshower through a Danze Drill bit/Barrena/Foret ) or supply elbow (D469058).
- Página 2 Repita los pasos 5-6 para el montante inferior. (Fig 7). NOTA: Se puede abastecer el agua para la ducha de mano usando un brazo de ducha Danze, un bifurcador (D481350) o un tubo abastecimiento (D469058). Fig 5 • Étapes d’installation: Ce produit est emballé...