Mellerware Petto! Drink Manual Del Usuario página 5

Put the rubber stopper in the
–
channel to prevent water leakage.
Press the rubber hard so that it is
well placed.
Fill with water up to approximately
–
1cm less than the line that surrounds
the entire interior of the water tank.
Place the filter base together with
–
the filter (G) in the main body.
Place the water tray (B) in the main
–
body.
Connect the charger cable (E) with
–
the charger (F) and plug in the
appliance.
After plugging in, the water pump
–
will cause water to flow into the
tray (B). This mode is used for any
pet.
If desired, the water fountain (A) can
–
be added to have another water
outlet mode. This mode is normally
used for cats.
This appliance has a LED light on
–
the water tank that indicates the
following:
- Blue light: correct water level
- Red light: lack of water
Cleaning
Disconnect the appliance from the
–
mains and allow it to cool before
undertaking any cleaning task.
After using this appliance for a long
–
time, the water tank must be
cleaned to prevent the growth of
bacteria that could affect the
health of your pet.
The following parts are suitable for
–
cleaning with detergent and water:
- Water tray
- Water fountain
- Water tank
- Main body
EN ES