Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Anemometer
Put the connector of the anemometer above the fastening accessory so that
the notches are aligned.
Turn the anemometer slightly counterclockwise to clockwise until it snaps
into place.
Holding the body of the anemometer in one hand, tighten the connector by
turning the screw counterclockwise (viewed from above) until you hear a
click.
Check that the anemometer is vertical. If necessary adjust the support to
achieve this.
To unscrew the anemometer, hold the body and with slight downward
pressure turn the screw clockwise (viewed from above)
Connector
Pin
Function
A
-
B
signal
C
-
D
-
E
-
F
-
G
signal
Electrical Schematic
Application
For a better equipment protection,
-Vin/GND should be earthed
8
Cable (optional)
-
green
-
-
-
-
yellow
anemomete
r
shield
F
A
E
G
B
D
C
Bottom view
Measurement equipment
signal
+Vin
signal
-Vin or GND
earth
f
Tabla de contenido
