Notice_Multithermo30
MEANING OF SYMBOLS
Temperature reading underway
Ear-temperature reading mode
Forehead-temperature reading mode
Temperature above 50°C
Temperature below 10°C
Degree Celsius
This symbol appears when the battery is
worn. You may still use the appliance but as
soon as "
" is displayed on the screen you
need to change the battery as this means the
appliance is no longer able to work properly.
Temperature below or above operating
conditions (16-40°C)
"
" & "
" Whenever either symbol is flashing
and the thermometer is making short and rapid
beep sounds, this means the appliance is not yet
ready for use. Press any button and wait for the
symbol to stop flashing.
SHUTDOWN
The thermometer will automatically shut itself
off after 30 seconds when no button has been
pressed.
CARING FOR
YOUR APPLIANCE
Clean the thermometer probe before and after
use with cotton wool dipped in alcohol. Do not
use abrasive products and do not place the
thermometer in water or any other type of liquid
as only the probe part is waterproof.
10
8/03/06
13:20
Page 10
PRECAUTIONS TO BE
TAKEN WHENUSING
1. Taking your temperature is merely a means of
controlling your state of health. It does not
give you the right to make a diagnosis or to
prescribe treatment. Unusual readings should
always be passed on to a doctor. Never alter
the dosage of medicine prescribed by a doctor.
2. Do not crush, drop or break the thermometer.
3. Keep out of reach of children.
4. Do not expose the thermometer to direct
sunlight or store close to a source of heat.
Store in a dry, clean area.
5. Do not place the thermometer in water or any
other type of liquid as only the probe part is
waterproof.
6. Multithermo 30 may only be used to take ear
or forehead temperature. Do not use to take
temperature via rectum, mouth or underarm.
7. Do not touch the tip of the probe with fingers.
8. Do not take temperature less than 30 minutes
after eating, exercising or bathing.
9. Take temperature at one-minute intervals.
Two successive readings may give slightly
different readings. In this case, the average of
both temperatures should be taken into
account.