Safety Information - HomeNetWerks 7130-08-BT Manual Del Usuario

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install
the product.
1. Always disconnect the power supply prior to servicing the fan, motor or junction box.
2. ,QVWDOODWLRQ ZRUN PXVW EH FDUULHG RXW E\ D TXDOL¿HG SHUVRQ V LQ DFFRUGDQFH WR DOO ORFDO DQG VDIHW\
FRGHV LQFOXGLQJ WKH UXOHV IRU ¿UHUDWHG FRQVWUXFWLRQ
3. )ROORZ DOO ORFDO EXLOGLQJ VDIHW\ DQG HOHFWULFDO FRGHV DV ZHOO DV 1(& 1DWLRQDO (OHFWULFDO &RGH
DQG 26+$ 2FFXSDWLRQDO 6DIHW\ DQG +HDOWK $FW 
 Electric service supply must be 120 volts, 60 hertz.
5. This unit must be properly grounded.
6. Do not bend or kink the power wires.
7. Exercise care to not damage existing wiring when cutting or drilling into walls or ceilings.
8. 6XI¿FLHQW DLU VXSSO\ LV UHTXLUHG IRU SURSHU FRPEXVWLRQ DQG WKH H[KDXVWLRQ RI JDVHV WKURXJK WKH
FKLPQH\ ÀXH RI IXHO EXUQLQJ HTXLSPHQW WR SUHYHQW EDFNGUDIWLQJ 6HH WKH VWDQGDUGV RI 1)3$
1DWLRQDO )LUH 3URWHFWLRQ $VVRFLDWLRQ DQG $6+5$( $PHULFDQ 6RFLHW\ IRU +HDWLQJ 5HIULJHUDWLRQ
DQG $LU &RQGLWLRQLQJ (QJLQHHUV DQG WKH ORFDO EXLOGLQJ FRGH DXWKRULWLHV
9. Do not use this fan with any solid state control device, such as a remote control, dimmer switch, or
certain timers. Mechanical timers are not solid state devices.
10. This ventilation fan is approved for use over a bathtub or shower when installed in a GFCI protected
circuit. Do not use fans over a bathtub or shower that are not approved for that application and
marked accordingly.
11. Do not use rigid conduit for installation.
12. Do not install in a cooking area.
13. Do not use to exhaust hazardous or explosive vapors.
 Fans should always be vented to the exterior and in compliance with local codes.
15. 'R QRW LQVWDOO LQ D FHLOLQJ ZLWK LQVXODWLRQ JUHDWHU WKDQ 5
16. Duct work should be installed in a straight line with minimal bends.
17. Duct work size must be the same size as the discharge and should not be reduced. Reducing
the duct size may increase fan noise.
18. Prior to service or cleaning this unit, shut off power supply at the panel and lock to prevent the
power from being turned on. If the panel cannot be locked, clearly mark the panel with a warning
tag to prevent the power from being turned on.
19. Use this unit in the manner intended by the manufacturer. If you have any questions, please call
customer service.
20. 7KH IDQ LV LQWHQGHG WR EH PRXQWHG DW OHDVW  IW  P DERYH WKH ÀRRU

www.homewerksww.com