Idiomas disponibles
Idiomas disponibles
2
CAUTION: Do not let the tensioner arm snap back to
the freearm position, severe damage may occur to the
tensioner.
1. Disconnect the negative cable from battery located
under passenger side front seat.
2. Open hood and remove the engine cover.
3. Remove the air cleaner body assembly.
4. Rotate the belt tensioner (7) until it contacts its stop.
Remove the belt (3) from the A/C compressor pulley
(4), then slowly rotate the tensioner (7) into the
freearm position.
5. Disconnect the engine wire harness from the A/C
compressor (2).
6. Remove the nut (5) and position the heater tube
bracket (4) out of the way.
7. Support the A/C compressor, remove the stud (3) and
the three bolts (1).
8. Reposition the A/C compressor away from the engine.
NOTE: The A/C compressor may be repositioned with
out disconnecting the refrigerant lines or discharging
the refrigerant system.
9. Position and install the engine block heater element
(3) and bolt (1) into the opening under the rear of the
exhaust manifold forward of the fluid level indicator/
dipstick (2).
10. Tighten the bolt (1) to 9 Nm (80 inlbs).
Sep 14, 2010
K6861086 REV1
