Tabla de contenido
Idiomas disponibles
Idiomas disponibles
E N G L I S H
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
For 115 V units with a power rating exceeding 1500 W,
we recommend to fit a plug to BS4343 standard.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
size is 1.5 mm
2
.
When using a cable reel, always unwind the cable
completely.
Also refer to the table below.
2
Conductor size (mm
)
0.75
1.00
1.50
2.50
4.00
Voltage
Amperes
115
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
Fitting a mixer basket (fig. B)
• Turn the mixer basket (6) into the tool holder (3).
• Once the basket has been fully turned into the
holder, tighten securely using an open-end
spanner (not included).
20
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5
15
25
30
45
Cable rating (Amperes)
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
10
15
20
20
15
15
20
25
25
20
20
25
-
6
6
6
6
6
6
6
6
6
6
6
6
10
10
10
10
10
15
15
15
15
15
20
20
20
20
20
25
Fitting the side handle (fig. A)
• Screw the side handle (4) into one of the
.
corresponding holes in the tool.
Fitting the spade handle (fig. A)
• Screw the spade handle (5) into the corresponding
hole on the back of the tool. Note that the spade
handle can be mounted in two different positions.
Instructions for use
Switching on and off (fig. A)
• To run the tool, press the variable speed switch
(1). The pressure exerted on the variable speed
switch determines the tool speed.
60
• If necessary, press the lock-on button (2) for
continuous operation and release the switch.
6
10
The lock-on button works only in full speed,
15
forward rotation.
20
• To stop the tool, release the switch.
25
• To stop the tool in continuous operation,
-
press the switch briefly and release it. Always
-
-
switch off the tool when work is finished and
6
6
before unplugging.
6
6
• Always switch off the tool when work is finished
15
and before unplugging.
15
20
• Do not use this tool to mix or pump
-
• Do not mix or stir inflammable liquids
Selecting the appropriate mixer basket
(fig. C1 - C4)
Refer to the table below for the appropriate mixer
basket to be used.
Always use the side handle!
Use the spade handle whenever
possible.
Always observe the safety instructions
and applicable regulations.
easily combustible or explosivefluids
(benzine, alcohol, etc.).
labelled accordingly.
Tabla de contenido
