Machine Usage - Gastrodomus SPRAY DYNAMIC Manual De Instrucciones

1) When button
value on the display starts flashing and access is given to the programming phase.
2) Pressing key
cycle. Pressing and releasing the key obtains a 1°C variation; when the key is pressed for 3
seconds, the variation is continuous. The work temperature regulation field (the values are
displayed on the display) ranges from 20°C to 92 °C and is divided into intervals of 1 °C.
3) The bottom temperature limit of 20°C is displayed on the display with the word OFF and switches
off the heating circuits both on the boiler and on the tube that connects the spray gun. In this phase
4) Once selected, the required temperature setting is confirmed by pressing the
15 seconds of selection, confirmation is not given, the selected value is cancelled and the existing
machine temperature appears on the display.
5) When the set temperature level is reached the
start the work cycle. The heating phase lasts approx. 15 minutes.
WARNING:
If the red led, at the bottom of the keyboard should come on
- If this led comes on and the wording Er1 appears on the display, this means that there is a
possible fault in the temperature monitoring system. In this case, switch off the electricity supply
to the machine by pressing the general switch, take out the electric cable plug from the electric
socket and contact the assistance service
- The red led can also signal that there is not enough liquid in the boiler and the wording Er2
appears on the display. In this case, open the rear door (see Fig. 1.2) with the special key and let
the boiler cool down. Unscrew the red cap situated on the upper part of the boiler and insert the
extension tube of the funnel supplied into the hole; distilled water must be used to fill up the boiler.
Once the water level of the boiler has been restored, the
of the machine will appear on the display. Screw the red cap back on and close the door.

MACHINE USAGE

Once the machine is set and running:
- remove the spray gun from its housing (see.Fig.3);
- mount the required nozzle onto the gun; unscrew the
fixing nut, insert the nozzle and screw tight again. The
machine is ready to be used.
- when you have finished the job, put the gun back in its
housing.
- switch the electricity supply to the machine off using the
general switch.
- remove the plug from the electric socket.
12
is pressed for 5 seconds the incorporated
or key changes the machine's temperature according to the required work
can be used to cold spray the product (liqueur or various liquids).
red led
green led comes on and the machine is ready to
(see Fig. 2.6), the machine will stop.
red led will go off and the temperature
Fig.3
comes on, the temperature
button. If within