Installing The Child Seat - Be Cool star Manual Del Usuario

EN

1. INSTALLING THE CHILD SEAT

TO INSTALL THE MOTION CHILD RESTRAINT SYSTEM
FOLLOW THE STEPS BELOW:
1.1- Unfold the support leg (15) until it is in the vertical
position as shown.
1.2- Move the button (11) to slide the ISOFIX connector
arms (9) backwards unfolding the connector fully. Do
this for both connector arms.
1.3- Guide the connector arms towards the ISOFIX
anchors in your vehicle until they lock together by
clicking into place and the indicator changes from red
to green on both sides of the base.
1.4- Move the seat backwards pressing the backrest
against the vehicle seat. Then pull the safety seat
towards you to check that it is securely locked in
place.
1.5- Press the button (14) to adjust the height of the
30
support leg (15) until it is firmly in contact with the
floor. It should not be on top of any type of
compartment. At this point make sure that the
support leg is at 90 degrees to the safety seat.
The visual ISOFIX indicators showwhether the con-
nector is open or closed. It may be that the connector
is closed but not locked into the ISOFIX anchor.
Please check that all the connectors are correctly
locked into the vehicle anchor points by pulling the
seat once it is installed.
TO DETACH THE SEAT FOLLOW THE SAME STEPS IN
REVERSE:
1.6- Move the button (12) to open the connector and
release it from the anchor point.