Troubleshooting - Stanley SXAE00135 Instrucciones De Uso

With the booster connected to the car battery and the green LED solid on the smart cable, turn on all
lights and electrical accessories for one minute. This draws current from the booster and warms the
battery. Now try to crank the engine. If it does not turn over, repeat the procedure. Extremely cold
weather may require two or three battery warmings before the engine will start.
IMPORTANT: DO NOT attempt to jump start your vehicle more than three consecutive times. If the
vehicle will not start after three attempts, consult a service technician.
3.3. To charge a mobile device, using the USB ports
The booster includes two USB ports. One provides up to 2,4A at 5V DC; the other is a Quick Charge
3.0™, which provides up to 5V at 3A, 9V at 2A or 12V at 1.5A.
1. Consult your mobile device manufacturer for proper charging power specifications. Connect
a mobile device cable to the appropriate USB port.
2. Slide the ON/OFF switch to the ON position. Charging should begin automatically. The
display will show which port is in use.
3. Charging time will vary, based on the mobile device's battery size and the charging port
used. NOTE: Most devices will charge with either USB port, but may charge at a slower rate.
4. When finished using the USB port, disconnect the charging cable from your mobile device
and then disconnect the charging cable from the unit. Slide the ON/OFF switch to the OFF
position.
5. Recharge the unit as soon as possible after each use.
NOTE: If no USB device is connected, power to the USB ports will automatically shut off after 30
seconds.
3.4. Maintenance
After unplug and disconnect the unit, use a dry cloth to wipe all battery corrosion and other dirt or oil
from the battery clamps, cords, and the outer case.
3.5. Storage
 Charge battery to full capacity before storage. Charge at least once every month, if not in frequent
use, to prevent over-discharge.
 Store this unit at temperatures between -10°C- +40°C.
4.

Troubleshooting

4.1. Booster
PROBLEM
The booster's display will not turn on.
The thermometer symbol is flashing.
The booster will not recharge.
The booster turns on, but won't jump start
my vehicle.
SOLUTION
Make sure the unit is charged.
Connect to a power source, to reset.
Make sure the ON/OFF switch is set to the ON
position.
The unit is too hot or cold. The thermometer symbol
will disappear when the condition is removed.
Make sure the power source is live.
Check connections.
Verify the charge level of the booster is at least 40%.
8