Compass Calibration - Overmax X-bee fold one Manual De Usuario

Gyroscope calibration
After connecting to the remote control, put the drone on a flat and horizontal surface and then
EN
direct both bars on the remote into bottom left corner (fig. 16). When green LEDs stop flashing
fast, it will mean that the calibration is over.
Note: the drone has already been calibrated. There is no need to calibrate again unless the drone
has difficulty in taking off or completing the detection procedure.

Compass calibration

NOTE: The compass calibration must be performed after detection mode. Calibration must
be performed before every flight and after replacement of the battery into new or after
putting it into the product.
1. Horizontal calibration
LEDs in the horizontal calibration mode will flash alternately in yellow. Keep the drone and
revolve horizontally on its axis. Make about three turns. When the calibration is correct, LEDs
will start flashing in green (fig. 17).
2. Vertical calibration
LEDs in the vertical calibration mode will flash alternately in green. Keep the drone vertically
(camera facing upwards) and revolve on its axis. Make about three turns. When the calibration
is correct, LEDS will glow constantly (fig. 18).
NOTE:
•
Do not calibrate the compass in a strong magnetic field.
•
When calibrating, do not wear any magnetic items (e.g. keys, phones).
•
When calibrating, keep a distance from large metal items
How to lock and unlock the drone
To lock and unlock the drone, you need to start drone motors.
To unlock the drone short press the lock key
be unlocked.
You can lock (stop motors) it in two ways:
1. When the drone lands on the ground, point the throttle bar downwards for about 3
seconds. Motors will stop and the drone will be locked.
2. The drone will switch off automatically if there is no operation for 15 seconds after
unlocking.
NOTE: Do not stop drone motors with
start falling.
.The motors will start and the drone will
key during the flight because the drone will