Voltage Probe; Earth Lead Accessory; Replacing The Smartfix Battery - Gallagher Smartfix Manual De Instrucciones

Voltage Probe

Use the Voltage probe in hard to reach areas such as Cut-out
switches. Touching the probe on a terminal will activate
the Smartfix to display a voltage reading. You should not
use the voltage probe for current readings as they will
not be accurate. The fence line needs to flow through the
measurement slot to obtain accurate current readings.
Note: Do not place the voltage probe on the
Energizer terminals. The Gallagher Smartfi x will not
give accurate results within 3m (10') of the energizer.

Earth Lead Accessory

The Smartfix has been
designed to give an
accurate
measurement of
voltage across a
wide range of
conditions. If
greater
accuracy is
desired the
Earth lead
should be used. If
you have an Earth Return
Fence system then use the Earth lead and
place it on the Earth wire. In all other
instances, placing your thumb
on the Earth Stud will be sufficient
(this will not give you a shock).
Replacing the
Smartfi x Battery
1. Remove the plastic caps
covering the 4 screws on the
back of the Smartfix with a
sharp object such as a small
screwdriver or knife.
2. Remove the screws and carefully pull the Smartfix apart.
3. Slide out the used battery and insert a new one.
4. Push the Smartfix back together.
Note: Make sure the black seal sits neatly in place
to ensure the Smartfi x is waterproof.
5. Replace the screws and press the screw caps into place.
7