Setting The Alarms; Crescendo Alarm - Oregon Scientific RM816P Manual Del Usuario

Setting the Alarm(s)
Instructions
1. Select the alarm you want to set by pressing the [ALARM] button.
2. Press and hold the [ALARM] button for 2 seconds when the selected Alarm is
displayed. The hours will blink.
3. Enter the values by pressing [UP ] or [Down ].
4. Confirm the entry by pressing the [ALARM] button.
5. The minutes will blink.
6. Repeat (3) and (4) to finish the setting. The alarm will be activated automatically.
7. Follow the same procedures to set and activate the Single and/or Weekday
Alarm.
To deactivate the alarm:
1. Select the alarm you want to deactivate by pressing the [ALARM] button.
2. Press [UP ] or [Down
played when the alarm is being deactivated.
3. To activate the alarm again, press [UP

Crescendo Alarm

When the alarm goes off at the preset time, the Alarm Icon (either Weekday Alarm
or Single Alarm , depending on which is enabled) will be flashing and the alarm will
be audibly ringing. The alarm sound starts off gently but gradually increases in vol-
ume and intensity for 2 minutes.
Press the [SNOOZE/LIGHT] button during the ringing to temporarily stop the alarm.
The alarm will sound again after 8 minutes unless another key on the clock is pressed.
To stop the ringing completely the first time, press the [ALARM] button.
The Single Alarm will automatically disable itself after the clock has gone off at
NOTE
the preset time.
The Weekday Alarm will still be enabled even after the alarm has gone off.
NOTE
] to deactivate the selected Alarm. "---" will be dis-
] or [Down
8
]