Idiomas disponibles
Idiomas disponibles
GB
READ THESE INSTRUCTIONS CAREFULLY BEFORE
USE AND KEEP THEM FOR FUTURE REFERENCE
WARNING: This seat has been designed to be operated as shown in the instructions supplied. Not to do so may
cause damage and render your guarantee void.
1-
FOOTREST: The footrest can be adjusted to 2 positions.
To lower or lift the footrest, press the bottom (D) and swing the footrest to the desired position.
2-
ADJUSTING BACKREST: The backrest can be adjusted to 3 positions.
behind the seat and simultaneously move it to the desired position.
NB. Always fasten the press-studs of hood, when using the seat in the horizontal position.
3-
HARNESS RESTRAINT: Shoulder adjustment is made by pulling the straps through the adjusters
indicated until a snug fit is obtained. Remember the amount of clothing your child is wearing will affect the
fit so check the adjustment each time the pushchair is used.
NB. "D" rings are located near the bottom of the backrest on the seat, and underneath the carrycot mattress
for the use of an additional harness complying with BS6684.
4- MAIN BUCKLE OPERATION (OPENING): Press simultaneously the two red buttons on the buckle, until
both clips separated from it.
5- MAIN BUCKLE OPERATION (CLOSING): Join the two clips together, and then fit it into the main buckle,
until it clicks firmly into position (check security by gently pulling in opposite direction).
6- BUMPER BAR: To remove the bumper bar, press the buttons on the armrest.
To fit, insert ends into armrests.
7- ADJUSTABLE BUMPER BAR: Press the side buttons and simultaneously rise or lower the bumper bar
as required.
8- To fit the hood, insert bayonet fitting into slots in armrests. To remove, press the buttons (E) on the armrest.
IMPORTANT - Never use the hood as a handle.
9- Unzip the hood to extend it and lift the rear flap for ventilation.
10- REMOVAL OF SEAT COVERS TO WASH: Remove harness restraint from seat cover.
Unfasten Velcro on seat and on the armrests. Lift cover from the backrest.
Note: To fit the seat fabric follow the steps in the reverse order.
IMPORTANT - Before washing, refer to the separate washing instructions included with this pushchair.
11- TO FIT SEAT: Seat may be forward or rear facing. Place seat on chassis attachment devise "easylock".
Lock will automatically engage.
engaged before use.
TO REMOVE SEAT: Push in button on both side of seat unit and lift seat away from chassis frame.
12- TO ADJUST THE HEIGHT POSITIONS OF THE HARNESS:
NB:
The shoulder harness has 3 height positions (i; ii and iii), please use the position that ensures the
straps are approximately level with the shoulders of the child.
1 Choose the correct height position of harness.
2 Use a screwdriver to remove plastic piece (J) from backrest housing.
3 Choose the correct housing (i; ii or iii) and fit plastic piece (J) into correct housing.
13-
TO ADJUST LENGTH OF THE HARNESS: The harness straps can be increased in length by unhooking
the harness strap 'B' from the metal bracket.
14-
TO FIT STRAPS TO SEAT COVER:
First check the correct position of the two clips of the main buckle (see Figure 3).
1 - Unzip back cover.
2 - Introduce buckles (G) into the opening of the seat fabric (A).
3 - Fasten harness straps (B) to buckles (G).
YOUR CHILD'S SAFETY MAY BE AFFECTED IF YOU
DO NOT FOLLOW THESE INSTRUCTIONS
Warning: Check that the seat unit attachment devices are correctly
Pull up the handle (C)
situated
