Sanus VisionMount VMFL1 Manual De Instrucciones página 6

3
Wall Mounting - Wood Stud
3-1
Locate stud
< 16 mm
(5/8 in.)
3-2
Level wall plate [01] and mark hole locations
3-3
Drill pilot holes as illustrated
3-4
Tighten lag bolts [03] only until they are pulled fi rmly against the wall plate [01]
[03]
6
Verify the center of the stud using an awl, a thin nail, or an edge to
edge stud fi nder.
CAUTION:
damage!
[01]
CAUTION:
lag bolt. To avoid potential injuries or property damage: pilot holes
MUST be drilled to a depth of 63.5 mm (2.5 in.), using a 3 mm (1/8
in.) diameter drill bit.
CAUTION:
lag bolt. To avoid potential injuries or property damage: DO NOT
over-tighten the lag bolts [03].
[01]
Avoid potential personal injuries and property
Any material covering the wall must not exceed 16 mm (5/8 in.).
Minimum wood stud size: common 2 x 4 in (nominal 1.5 x 3.5 in).
Improper use could reduce the holding power of the
63.5 mm
(2.5 in.)
Improper use could reduce the holding power of the
3 mm
(1/8 in.)
6901-002131 <00>